DSTIKE WATCHV4 Deauther Watch Instructions
- June 5, 2024
- DSTIKE
Table of Contents
Fast tutorial
- Charge your watch until RED LED OFF(V1) or 4 GREEN LEDs are all ON(V2, V3, V4).
- SELECT-, APs – > Your target(Select only one target.).
- Back x2 ->ATTACK-> DEATH -‘START (RGB LED turn RED)
- STOP (RGB IED turn GREEN).
- Connect wifi to pwned. (Password: daughter)
- Use Chrome browser to open 192.168.4.1
- Select AP target or Station target
- Attack Death starts. (Select only one attack method one time).
Attention: You can change settings via the chrome browser. But if you
select multiple tarpits to attack at the second step, you may not find pwned
to connect.
Scan this.tp solve more prbbletils about daughter, How to Reset/I forgot the
password)
https://github.com/spacehuhn/esp8266_deauther/wiki
FCC ID: 2A4ZP-WATCHV4
FCC Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate this
equipment. This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. This device and its
antenna(s) must not be co-located or operating in conjunction with any other
antenna or transmitter.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>