Razor MX500 Dirt Rocket Adult & Teen Ride On High-Torque Electric Motocross Motorcycle Dirt Bik Instructions
- June 5, 2024
- Razor
Table of Contents
Razor MX500 Dirt Rocket Adult & Teen Ride On High-Torque Electric
Motocross Motorcycle Dirt Bike
Required Tools
- Two (2) 19 mm Wrenches
- Phillips screwdriver
WARNING: To avoid potential shock or other injury, turn power switch OFF and disconnect charger before performing any assembly or maintenance procedures. Failure to follow these steps in the correct order may cause irreparable damage.
- Using a Phillips screwdriver, loosen screws and remove chain guard.
- Using two (2) 19 mm wrenches, loosen both axle nuts.
- Push the chain tensioner down to loosen the chain and remove the chain from the wheel sprocket and motor sprocket. Push and remove the wheel downward. Note: Your hands will get greasy doing this.
- Note: the arrangement of the hardware sequence:
Right Side (Throttle): Left Side (Brake)
- 16-1 Nut: 16-1 Nut
- 16-2 Washer: 16-2 Washer
- Frame: Frame
- 16-3 Spacer: 16-3 Spacer
- Install the new chain or wheel by slipping the chain around the axle. Slide the axle into the slots on the frame. Slide the chain tensioner down and maneuver the chain onto the rear sprocket and motor sprocket.
- Reattach the chain guard. Test ride and check. Readjust as needed.
- Attention: Charge battery for 12 hours before using.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>