LANGNA LN-R1 Remote Control Instruction Manual
- June 5, 2024
- LANGNA
Table of Contents
LANGNA- LN-R1 -Remote -Control
REMOTE CONTROL
- first use, installed on the remote control battery, the gear indicator light is often bright, and then open the child’s total power supply, without the code, for the code state, can be operated.
- if we need to shut down the power of the baby car on the code, then press the M key for 5 seconds, then the stall lamp flickers, then undo the M key, and then open the power of the baby carriage. The position lamp is always bright, indicating that the code is successful. At this time, the remote controller and the receiver are used for one to one.
- if the code is needed again, turn off the total power of the baby car, press the M key for more than 8 seconds, the stall lamp flickers, and then release the M key to open the total power supply of the baby carriage. The position lamp is always bright, which indicates that the pass state is successful.
- if you press any key of the remote control and find the light is not bright, please replace the battery in time. Please take out the battery when you don’t need it for a long time.
- the remote control needs adult operation to avoid accidents. The color of the picture is only a reference, and the object is specific.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. RF Exposure Information The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>