Shenzhen Snd Electronics SND-478 Remote Control User Guide
- June 5, 2024
- Shenzhen Snd Electronics
Table of Contents
Shenzhen Snd Electronics SND-478 Remote Control
INTRODUCTION FOR KEY FUNCTIONS
HOW TO PAIR WITH CONSOLE?
First Step :
Power on the console.
Second Step:
Open the back cover of the remote controller, then put it into two new M
batteries. You will find a small red SYNC button beside the battery slot.
Press the SYNC button, and FOUR lights (the Player LED) on the controller will
flash.
Third Step:
Open the SD slot on the console, you will find a red SYNC button next to the
SD slot. Then press this SYNC button.
Fourth Step:
Wait for a few seconds, the Player LED on the controller will stop flashing
and light up when paring is complete. The Player LED indicates the player
number of the controller currently in use.
NOTES:
- Powered by 2 AA batteries (batteries are not included and you need to purchase them.)
- This controller is designed by a third-party company, not made by Nintendo, and perfectly fits the console.
How to connect Wireless Remote Controller and Nunchuk?
Nunchuk can be directly connected to the Expansion Port of the Wireless
Controller, then can use. (Nunchuk cannot be used alone)
Note: Press the Lock/Unlock Lever on both sides of the Nunchuk data cable
plug, and the plug can be easily unplugged from the wireless remote
controller.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television
reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>