UniFi Protect G3 Flex Camera Installation Guide
- June 3, 2024
- Unifi
Table of Contents
G3 Flex Camera
Installation Guide
Protect G3 Flex Camera
Safety Notices (if applicable)
- Read, follow and keep these instructions.
- Heed all warnings.
- Only use attachments/accessories specified by the manufacturer.
WARNING: Failure to provide proper ventilation may cause fire hazards.
Keep at least 20mm of clearance next to the ventilation holes for adequate
airflow.
WARNING: To reduce the risk of fire or electric shock, do not expose this
product to rain or moisture.
WARNING: Do not use this product in a location that can be submerged in
water.
WARNING: Avoid using this product during an electrical storm. There may
be a remote risk of electric shock from lightning.
Electrical Safety Information (if applicable)
- Compliance is required with respect to voltage, frequency, and current requirements indicated on the manufacturer’s label. Connection to a different power source than those specified may result in improper operation, damage to the equipment, or pose a fire hazard if the limitations are not followed.
- There are no operator-serviceable parts inside this equipment. Service should be provided only by a qualified service technician.
- This equipment is provided with a detachable power cord which has an integral safety ground wire intended for connection to a grounded safety outlet.
a. Do not substitute the power cord with one that is not the provided approved type. Never use an adapter plug to connect to a 2-wire outlet as this will defeat the continuity of the grounding wire.
b. The equipment requires the use of the ground wire as a part of the safety certification, modification or misuse can provide a shock hazard that can result in serious injury or death.
c. Contact a qualified electrician or the manufacturer if there are questions about the installation prior to connecting the equipment.
d. Protective earthing is provided by the Listed AC adapter. Building installation shall provide appropriate short-circuit backup protection.
e. Protective bonding must be installed in accordance with local national wiring rules and regulations.
Declaration of Conformity
Hereby, UBIQUITI, declares that this device, UVC-G3-FLEX, is in compliance
with the essential requirements and other relevant provisions of Directives
2014/30/EU, 2014/35/EU. The full text of the EU declaration of conformity and
detailed compliance information is available at the following internet
address: ui.com/compliance
Ubiquiti International Holding B.V.
Ekkersrijt 3102, Son, Netherlands
http://ui.com/qig/uvc-g3-flex
640-00674-01
Documents / Resources
|
UniFi Protect G3 Flex
Camera
[pdf] Installation Guide
Protect G3 Flex Camera, Protect G3, Flex Camera, Protect G3 Flex, Camera,
Protect G3 Camera, G3 Camera
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>