Guangzhou Rantion Technology MK0096 Professional Wireless Microphone User Manual
- June 5, 2024
- Guangzhou Rantion Technology
Table of Contents
Guangzhou Rantion Technology MK0096 Professional Wireless Microphone
Product Feature
- SMT technology with good quality and long operating.
- High Anti-interference;Prevent the interference from computers, DVD and Digital power amplifiers.
- Prevent squeaking:Switch impulse noise canceling circuit.
- High sensitivity,Voice high fidelity;wide frequceny response and good tone quality. Application
Apply to Family Karaoke; Computer Karaoke;Video chat;Product promotion; Outdoors lecture;Teaching; Military traning; Tour guide;Exhibition and Small promotional sites.
Specification
-
Frequency range:174-216MHz Operating distance:60-100M Frequency Stability:150PPM(-10℃-35℃
-
Working temperature: -10℃-35℃) equency response:60Hz-13KHz
Receiver: -
Receiving Sensitivity:>12Dbu(s/n=40Db) Power supply:3V (2*AA batteries) Operating current:<30mA
Instructions
Receiver Instructions Take out the battery cover and install the 2* AA
batteries (NO.5 battery) according to the correct polarity. Open the switch .
The indicator is weak and bright.After open the receiver the signal will be
more bright.Put the plug into the amplifier,then the mic can be used normally.
Handheld transmitter
-
Take out the battery cover and install the batteries,push the switch to “ON” that it can work normally.
-
When the indicator in bright,the battery power is lower,it should be replaced the batteries.
Notice: -
When the battery low. the microphone will appear noise,modified tone,staccato appear,the batteries should be replaced.
-
Push the power switch to “OFF” after using microphone.
-
In order to avoid the damage of components,battery acidification or weeping,please take out the batteries when long time no use.
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: This device may not cause harmful interference,
and this device must accept any interference received, including interference
that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>