KRAMER KDOCK-4-HOLDER Multiport Adapter Instruction Manual
- June 5, 2024
- Kramer
Table of Contents
KRAMER KDOCK-4-HOLDER Multiport Adapter
KDOCK-1/2/3-HOLDER
Congratulations on purchasing your Kramer KDOCK-1/2/3-HOLDER / KDOCK-4-HOLDER for safely securing KDock USB-C Hub Multiport Adapters below or on a surface. This document describes how to secure the KDOCK-1/2/3-HOLDER and the KDOCK-4-HOLDER to a surface.
Installing the KDOCK-1/2/3-HOLDER
KDOCK-1/2/3-HOLDER can be installed either under or above a surface. In this example, it is installed under a table.
To secure the KDOCK-1/2/3-HOLDER under a table:
- Insert the KDock device into the clamp, in-between the rubber pads.
- Insert a washer (supplied) and then a nut (supplied) onto each of the studs and tighten.
- Check the location under the table where you want to install the device and mark the location for the two installation screws (supplied).
- Use the two installation screws to secure the KDOCK-1/2/3-HOLDER under the table.
Installing the KDOCK-4-HOLDER
KDOCK-4-HOLDER can be installed either under or above a surface. In this
example, it is installed on a table. Note that when it is installed under, the
flip-up device holder cannot be used.
To secure the KDOCK-4-HOLDER on a table:
- Place the KDock-4 device on the surface, at the correct location.
- Place the KDOCK-4-HOLDER over the device.
- Insert the four screws and secure the KDOCK-4-HOLDER to the table.
Technical Specifications
| Environmental Conditions | Operating Temperature | 0° to +40°C (32° to 104°F). |
|---|---|---|
| Storage Temperature | -10° to +55°C (14° to 131°F). | |
| Humidity | 5% to 90%, RHL non-condensing. | |
| Regulatory Compliance | Safety | CE. |
| Environmental | RoHs | |
| Enclosure | Materials | Zinc-coated steel and rubber padding (for |
KDOCK-1/2/3-HOLDER only)
General| Net Dimensions (W, D, H)| KDOCK-1/2/3-HOLDER : 3cm x 6.5cm x 1.9
cm (1.2″ x 2.6″ x 0.75″) Approx.
| | KDOCK-4-HOLDER : 26.2cm x 7.1cm x 2.5cm
(10.3″ x 2.8″ x 1″) Approx.
| Shipping Dimensions (W, D, H)| KDOCK-1/2/3-HOLDER : 12.1cm x 8.2cm x
4.1cm (4.8″ x 3.2″ x 1.6″)
| | KDOCK-4-HOLDER : 36.6cm x 21cm x 7.7 cm (14.4″ x 8.27″ x 3″)
| Net Weight| KDOCK-1/2/3-HOLDER : 50g (0.11lbs) approx.
KDOCK-4-HOLDER : 201g (0.44lbs) approx.
| Shipping Weight| KDOCK-1/2/3-HOLDER : 90g (0.2lbs) approx.
KDOCK-4-HOLDER : 261g (0.6lbs) approx.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>