Cigna AW201 WiFi Door and Window Smart Intelligent Alarm Instruction Manual
- June 5, 2024
- Cigna
Table of Contents
WiFi Intelligent Alarm
Operation
Instruction
Appearance Introduction
Installation
- Way for battery installation
1 Open the cover of the emitter
2. Place tow 7# batteries (AAAbatteries)Properly
3.End of battery
installation
4. Close the rear cover
Tuya smart
- Download APP
|
---|---
https://smartapp.tuya.com/tuyasmart| https://smartapp.tuya.com/smartlife
➢Scan the two-dimensional code and download “Tuya Smart or (Smart Life)”.
➢OS: please download the “Tuya Smart or (Smart Life)” at apple application
market.
➢Android: please download the “Tuya Smart or (Smart Life)” at application
market.
2.Register/login Tuya Smart
3 . Network with Mobil Phone (two methods)
Method 1:
Wi -Fi Quick Connect
| |
---|---|---
|
Method 2: Hotspot
distribution network
|
| |
| |
Way for fixing and installation
3M glue fixing @ Tear off each side of release paper on two foam glue, and
attach two foam glues respectively onto the fixing surfaces of the emitter and
the magnetic stripe ( as shown in Figure 1 ). 0 Tear off the release paper on
the back of the remitter and the magnetic stripe and attach it at the
installation position of a door or a window ( as shown in Figure 2).
Maintenance
- Change the battery’s Battery lower power warning: When the battery power is lower than 20%, the APP will warn that the battery needs to be replaced.
remove the outer casing
2. Use a screwdriver to take out the battery from the side
Testin the emitter
specifications
Working voltage; DC3V (LRO3AAA*2) Static current: 30RA Transmitting current:
35mA Working environment: 0°C – +50°C WiFi: IEEE 802 11 b/g/n 2.4GHz Alarm
output: Tamper alarm,Open door reminder, Closing reminder, Low battery warning
FCC WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Any changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment. NOTE: This equipment
has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to by to correct the interference
by one or more of the following measures: — Reorient or relocate the receiving
antenna. — Increase the separation between the equipment and receiver. —
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected. — Consult the dealer or an experienced radio/TV
technician for help. To maintain compliance with FCC’s RF exposure guidelines,
This equipment should be installed and operated with a minimum distance
between 20cm the radiator your body: Use only the supplied antenna.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>