elgato 10GAP9901 4K60 S+ Capture 4K HDR User Guide
- June 5, 2024
- elgato
Table of Contents
elgato 10GAP9901 4K60 S+ Capture 4K HDR User Guide
PC Recording
Download Elgato 4K Capture Utility to get started.
LED Status
| |
---|---|---
Device connected to PC via USB| Recording – Slow flashing|
| |
Standby – Slow flashing| Booting – Flashing| Error message – Rapid flashing
(no signal, HDCP, SD card error, SD card locked, SD card full, SD card too
slow)
When using 4K60 S+ for PC recording, POWER and USB must be connected.
Only use the power supply shipped with your product.
SD Card Recording
LED Status
| |
---|---|---
Ready to start recording (requires valid input signal)| SD card recording –
Slow flashing| Processing SD card recording – Rapid flashing
| |
Standby – Slow flashing| Booting – Flashing| Error message – Rapid flashing
(no signal, HDCP, SD card error, SD card locked, SD card full, SD card too
slow)
When using 4K60 S+ for SD card recording, only POWER must be connected. Do not
connect USB to your PC. Only use the power supply shipped with your product.
Minimum SD card speed: UHS Class 3 / V30
Formatting: FAT32 or exFAT
To avoid file corruption, do not remove the SD card immediately after recording has stopped (while recording is being processed). Wait until the red LED stops flashing rapidly
PC Recording
SD Card Recording
THIS PRODUCT HAS BEEN DESIGNED TO ASSIST YOU IN REPRODUCING MATERIALS IN WHICH YOU OWN THE COPYRIGHT OR HAVE OBTAINED PERMISSION TO COPY FROM THE COPYRIGHT OWNER. UNLESS YOU OWN THE COPYRIGHT OR HAVE OBTAINED PERMISSION TO COPY FROM THE COPYRIGHT OWNER, YOU MAY BE VIOLATING COPYRIGHT LAW AND BE SUBJECT TO PAYMENT OF DAMAGES AND OTHER REMEDIES. IF YOU ARE UNCERTAIN ABOUT YOUR RIGHTS YOU SHOULD CONTACT YOUR LEGAL ADVISOR.
Federal Communication Commission Interference Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user‘s authority to operate this equipment
For questions about Elgato product compliance with FCC regulations, please
contact:
Compliance Officer, Corsair Memory Inc., 47100 Bayside Pkwy, Fremont, CA
94538, USA
Rating: 5 V, min 2.4 A
+ R-R-CSI-20GAP9901
Applicant Name : Corsair Memory, Inc.
Product Name : Game Capture 4K60 S+
Model No. : 20GAP9901
Manufactured Year & Month : Please refer to gift box sticker
Manufacturer & Country of Origin : Corsair Memory, Inc./ Made in Taiwan
Part: 51GAP9902
/elgatogaming