Shenzhen Vstarcam Technology CS49 IP Camera User Manual
- June 5, 2024
- Shenzhen Vstarcam Technology
Table of Contents
Shenzhen Vstarcam Technology CS49 IP Camera
Product Description
How to reset the camera
- Power on the camera and wait for the boof to complete.
- Using a needle to hold on the reset button for about 5 seconds until you hear a prompt “Reset completed”.
Camera Installation
- Punch the hole according to the hole position of the bracket.
- Embed the expansion rubber plug.
- Fix the bracket with screws and fix the camera on the stand.
Pre-Setup
- Connect your phone to the WiFi network ( 2 .4GHz only).
- ‘Power on the camera and wait for about 30 seconds to finish booting. is your first time to connect the camera, there is no need to reset it.
- If you cannot hear ” Please use APP for WiFi configuration” when the camera startups, please reset the camera. Reset method: Using a needle to hold on the reset button for about 5 seconds until you hear”Reset completed” (You can find the reset button from “Product Description”)
APP Download and Registration
- Scan the QR code to download the App.
- Click “Register”, and enter the user name and password to complete the registration.
Note: PC client and other tools can be downloaded at https://www.cam366.com
- Click add device and select IP camera.
- Choose the sound wave way and follow the instructions.
- After about 60 seconds, the binding interface will appear and the camera password will be required to be changed later.
Configure Wifi
- Select WiFi settings
- Enter camera parameters
Note: During WiFi configuration, please do not unplug the camera power supply. Please don’t unplug the network cable until the wifi configuration is done (which will take about 60s) Select your home WiFi and enter the WiFi password correctly.
Cloud storage
The camera supports cloud storage service. After activated the cloud storage service, when the motion detection is triggered, the video will be uploaded to the cloud storage server immediately, and the video can be viewed even if the camera is stolen.
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures: Reorient or relocate
the receiving antenna. Increase the separation between the equipment and
receiver. Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected. Consult the dealer or an experienced
radio/TV technician for help.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
a minimum distance 20cm between the radiator & your body.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>