DCOLOR DVB-T2 High Definition Digital Terrestrial Receiver User Manual
- June 5, 2024
- DCOLOR
Table of Contents
**Dcolor ** High Definition Digital Terrestrial Receiver
H.265 DVB-T2 TV Stick
Simply Upgrade Your TV to DVB-T2
Happy? Tell the whole world
Unhappy? Contact us to get help
Packing list
Functional Port
Upgrade to DVB-T2
Attention
- Place the IR Receiver in front of your TV
Not behind it
DVB Remote Control
POWER: turn ON/OFF the DVB device
TV Control
POWER:turn ON/OFF the TV
SET: auto-learning setting
MEDIA Control
| Show the REC
media via the USB device
---|---
Switch 720P or 1080P
Switch 16:9 or 4:3
Book listing control
Show the subtitles (if available)
Skips to the previous channel
MENU Control
| Electronic guide (if available)
---|---
Info of the channel
MENU: open the main menu
EXIT: Exit from a menu
MORE Control
| AUDIO: selects the language of the channel
---|---
TTX: teletext ( if available)
FAV: creates and shows the list of the favorite channels
REC: start recording in the USB device
PAGE: navigate inside the menu
CHANNEL Control:
TV/RADIO: switch TV or Radio channel
Remote Auto -learning Set
Only these 4 keys of DVB remote can be learned
, Use as an example
All these keys can be set up via steps 1~5
Troubleshooting
| Problem | Possible cause | Solutions |
|---|
The front panel
display does not turn on| Lack of tension| Make sure the power cord is
properly inserted into a powered outlet Verify that the switch is turned on
No image or sound| The cables connecting the TV and the decoder are not
connected correctly| Check that the output signal cable is well connected
(SCART or HDMI). Also check the antenna cable.
TV mode is incorrect| Make sure you have selected the correct input signal on
the TV (SOURCE or INPUT key on the TV remote control)
Incorrect video definition| Press V-FORMAT on the remote control and select a
video resolution that allows correct viewing
Intermittent t picture
and audio| Insufficient signal strength| Check that the antenna cable is well
connected and that the quality of the video signal is adequate.
Electrical interference| Check that the antenna cable is completely shielded
No audio| The receiver or TV is in silent mode| Disable silent mode using the
MUTE button
Volume level too low| Check that the volume level of the set-top box and
television are adequate
Audio CODEC is not supported| While watching multimedia content, audio
encoding may not be supported (while video encoding may be) and movies may
appear without audio. The file is not completely readable.
The remote control not working| Batteries not inserted| Insert the batteries
into the remote control
Low battery| Replace the batteries
Polarity reversal of batteries| Check that the batteries have been inserted
according to their correct polarity, as indicated on the bottom of the battery
compartment.
The remote control is out of its operating range| Approach and point the
remote control directly at the appliance.
Media files on the USB stick are
not played| The files are not of the supported format| Only some formats are
supported
The compression codec is not supported| Only some codecs are supported
Contactus for help: dcolorteam@gmail.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>