TRiSTAR KA-5090 Infrared Panel Heater Instruction Manual
- June 13, 2024
- Tristar
Table of Contents
TRiSTAR KA-5090 Infrared Panel Heater
Product Information
- Product Name: Tristar Heater
- Manufacturer: Tristar Europe B.V.
- Address: Swaardvenstraat 65, 5048 AV Tilburg, The Netherlands
- Compliance: This product complies with the conformity requirements of the applicable European regulations or directives.
Product Description
Parts Description
- On/Off switch
- Temperature control knob
- Power cord
- Feet of the heater
Product Usage Instructions
- Safety Precautions:
- Do not dispose of waste electrical products with household waste. Recycle them where facilities exist. Check with your local authority or store for recycling advice.
- Follow your local municipal guidelines for separate collection and disposal of the product and packaging materials.
- The Triman logo is valid in France only.
- Electronic and electrical equipment not included in the selective sorting process should be disposed of at an approved waste or recycling facility.
- Placement and Setup:
- Place the heater on a stable and heat-resistant surface, keeping it at least 12cm away from any edges.
- Ensure that the feet of the heater are properly attached to provide stability.
- Operation:
- Use the On/Off switch (part 1) to turn the heater on or off.
- Adjust the desired temperature using the temperature control knob (part 2).
- Cleaning and Maintenance:
-
* Before cleaning, make sure to turn off and unplug the heater, allowing it to cool down.- Clean the surface of the heater using a soft, damp cloth.
- Do not use abrasive cleaners, scouring pads, or steel wool, as they can damage the device.
For further information and spare parts, visit the Tristar website at www.tristar.eu. Please note that the provided instructions are a general guide. Always refer to the specific user manual of your Tristar Heater for detailed instructions and safety information.
SAFETY
- By ignoring the safety instructions the manufacturer cannot be held responsible for the damage.
- If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
- Never move the appliance by pulling the cord and make sure the cord cannot become entangled.
- The appliance must be placed on a stable, level surface.
- The user must not leave the appliance unattended while it is connected to the supply.
- This appliance is only to be used for household purposes and only for the purpose it is made for.
- This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instructions concerning use of the appliance in a safe way and understand the hazards involved.
- Children shall not play with the appliance.
- Cleaning and user maintenance shall not be made by children without supervision.
- Children of less than 3 years should be kept away unless continuously supervised.
- Children aged from 3 years and less than 8 years shall only switch on/off the appliance provided that it has been placed or installed in its intended normal operating position and they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.
- Children aged from 3 years and less than 8 years shall not plug in, regulate and clean the appliance or perform user maintenance.
- To protect yourself against an electric shock, do not immerse the cord, plug or appliance in the water or any other liquid.
- WARNING: Some parts of this product can become very hot and cause burns. Particular attention has to be given where children and vulnerable people are present.
- Do not use this heater in the immediate surroundings of a bath, a shower or a swimming pool.
- Joists, beams and rafters shall not be cut or notched to install the appliance.
- Please do not install the appliance close to curtains and other combustible materials. This could cause a fire.
- The appliance shall, under no circumstances, be covered with insulating material or similar material.
- The heater must not be located immediately below a socket-outlet.
- Do not use this heater if it has been dropped.
- WARNING: The heater must not be used if the glass panels are damaged.
- Use this heater on a horizontal and stable surface, or fix it to the wall, as applicable.
- WARNING: Do not use this heater in small rooms when they are occupied by persons not capable of leaving the room on their own, unless constant supervision is provided.
- WARNING: To reduce the risk of fire, keep textiles, curtain, or any other flammable material a minimum distance of 1m from the air outlet.
- The heater needs to be installed so that the switches and other controls cannot be touched by a person in the bath or shower.
- WARNING: In order to avoid overheating, do not cover the heater. Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your local Authority or local store for recycling advice.
- This product complies with conformity requirements of the applicable European regulations or directives.
- The Green Dot is the registered trademark of Der Grüne Punkt Duales System Deutschland GmbH and is protected as a trademark worldwide. The logo may only be used by customers of DSD GmbH holding a valid trademark usage contract or by engaged waste management companies within the Federal Republic of Germany. This also applies to reproduction of the logo by third parties in a dictionary, an encyclopaedia or an electronic database containing a reference manual.
- Separate collection / Check your local municipal guidelines.
- The product and packaging materials are recyclable, subject to extended manufacturer responsibility. Dispose it separately, following the illustrated packaging symbols, for better waste treatment. The Triman logo is valid in France only.
PARTS DESCRIPTION
- On / Off switch
- Temperature control knob
- Power cord
- Feet
INSTALLATION
Foot assembly
- Place the feet and secure them by putting the screws into the housing.
- Take care to ensure that the feet are located correctly on the bottom end of the heater. (at most 12cm from the edge of the item)
BEFORE THE FIRST USE
- When the device is turned on for the first time, a slight odour will occur. This is normal, ensure adequate ventilation. This smell is only temporary and will soon fade.
- During heating up and cooling down there may be some noises caused by the heater casing expanding and contracting, this is normal and does not indicate any fault.
- Connect the power cable to the socket. (Note: Make sure the indicated voltage on the device matches the local voltage before connecting the device. Voltage 220V-240V~ 50-60Hz.)
USE
- Plug in the power plug and rotate the temperature control knob to maximum.
- Push the on/off switch of the heater to turn the heater on, indication lamp will illuminate.
- Push the on/off switch to the off position to turn the heater off.
- Remove the plug from the socket when not using the heater for a while.
CLEANING AND MAINTENANCE
- Before cleaning, unplug the appliance and wait for the appliance to cool down.
- Clean the appliance with a damp cloth. Never use harsh and abrasive cleaners, scouring pad or steel wool, which damages the device.
ENVIRONMENT
The crossed out wheelie bin symbol means that this product shall not be disposed of with normal household waste. Electronic and Electrical Equipment not included in the selective sorting process are potentially dangerous for the environment and human health due to the presence of hazardous substances. Please dispose of responsibly at an approved waste or recycling facility.
Support
You can find all available information and spare parts at www.tristar.eu!
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>