TYPE S LM58276 Multicolor LEDs and Brake Light Instruction Manual
- June 5, 2024
- TYPE S
Table of Contents
TYPE S LM58276 Multicolor LEDs and Brake Light
PACKAGE CONTENTS
TECHNICAL SPECIFICATION
- Working voltage: DC 12V only
- Maximum amperage draw: 1.6A
- Watt: 19.2W
- LEDs: 144 x 3528 RGB
- Replacement Fuse: 3A
- IP Rating of LED Strip: IPX4
INSTALLATION
- Clean the trunk surface thoroughly with isopropyl alcohol. Dry completely.
- Apply adhesive promoter on the surface.
- Peel off the 3M™ VHB tape backer and carefully attach the LED Spoiler to the trunk surface.
POWER
- Run the wire through the bottom of the trunk.
- Connect either on the car battery or any 12V source from your car.
- Hub controller hardwires cables are color-coded, RED for POSITIVE (+), BLACK for NEGATIVE (-), and YELLOW for Brake Light POSITIVE (+).
Connect the RED cable to the POSITIVE (+) battery clamp. The POSITIVE battery post will be slightly larger than the NEGATIVE post and will be marked with a PLUS (+) sign. There may also be a RED protective cover over the positive battery post. – Connect the BLACK cable to the NEGATIVE (-) battery clamp. The NEGATIVE will be marked with a MINUS (-) sign. There may also be a BLACK plastic protective cover over the negative battery post. Hardwire the YELLOW brake light cable to the Brake Light POSITIVE (+), and test the brake light to ensure the wires are connected correctly. NOTE: For use with 12V power only.
OPERATION
- Press Controller Button to cycle through 15 color options.
- Press and hold Controller Button for 3 seconds to turn off the Spoiler LED while the brake light is still functioning.
WARNING
do not install or use the product if it, in any way, impairs the safe
operation of your vehicle. Follow the manufacturer’s instructions to ensure
the product is properly & safely installed. Neither the manufacturer nor the
reseller can be held responsible or liable for consequential, incidental, or
indirect damages to either person or property resulting from the installation
or improper use of this product. Check your state or provincial laws before
installing. This product is not DOT approved and is designed for intended use
only (for interior cabin). Not for use in extreme temperatures such as
underhood applications. This product is intended solely for decorative
purposes. Check local laws and regulations regarding installation and use. The
manufacturer and seller assume no liability for improper installation or use,
which are solely the responsibility of the purchaser.
WARNING: This product can expose you to chemicals including DEHP and
DINP, which are known to the State of California to cause cancer and birth
defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>