elgato 10MAG9901 Wave XLR Dynamic Microphone User Guide
- June 5, 2024
- elgato
Table of Contents
elgato 10MAG9901 Wave XLR Dynamic Microphone
INSTALLATION
Condenser microphone = 48V LED must be ON. Dynamic microphone = 48V LED must
be OFF.
Toggle phantom power by pushing the control dial for 2 seconds.
Connect your mic using a standard XLR microphone cable.
Connect your headphones to the 3.5 mm jack.
Keep the monitoring volume moderate to protect your hearing!
Push the control dial to toggle between Mic Gain, Headphone Volume, and Mic/PC Mix.
Tap the capacitive sensor on the back of the unit to mute or unmute.
Easily switch out the faceplate to personalize your setup.
Download Elgato Wave Link app at komme i gang:
Federal Communication Commission Interference Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the
party responsible for compliance could void the user‘s authority to operate
this equipment. For questions about Elgato product compliance with FCC
regulations, please contact: Compliance Officer, Corsair Memory Inc., 47100
Bayside Pkwy, Fremont, CA 94538, USA
THIS PRODUCT HAS BEEN DESIGNED TO ASSIST YOU IN REPRODUCING MATERIALS IN WHICH
YOU OWN THE COPYRIGHT OR HAVE OBTAINED PERMISSION TO COPY FROM THE COPYRIGHT
OWNER. UNLESS YOU OWN THE COPYRIGHT OR HAVE OBTAINED PERMISSION TO COPY FROM
THE COPYRIGHT OWNER, YOU MAY BE VIOLATING COPYRIGHT LAW AND BE SUBJECT TO
PAYMENT OF DAMAGES AND OTHER REMEDIES. IF YOU ARE UNCERTAIN ABOUT YOUR RIGHTS
YOU SHOULD CONTACT YOUR LEGAL ADVISOR.
Model No. 20MAG9901
Manufactured Year & Month: Please refer to gift box sticker Manufacturer &
Country of Origin
Corsair Memory, Inc./ Made in China
A/S : 1522-1460
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>