SVP AEROSPACE LNA-2GHz Low Noise Amplifier Instruction Manual
- June 5, 2024
- SVP AEROSPACE
Table of Contents
SVP AEROSPACE LNA-2GHz Low Noise Amplifier Instruction Manual
Dear Customer,
We would like to thank you for choosing this equipment and welcome you to the
SVP’s growing family of products.
We are sure that the addition of this equipment to your existing installation will cause you nothing but satisfaction.
Please read these instructions carefully, and keep them at hand in case you have to refer to them.
IMPORTANT NOTES:
- The LNA low noise preamplifier for COFDM signals has a selective input filter, which can be modified under request of the customer in order to work in the wanted frequency range.
- The COFDM low noise preamplifier is powered through the output coax connector. For it, a bias insertion tee (BIAS-TEE) can be used, which is an accessory available in our catalogue.
- The high performance of this equipment is only guaranteed using high quality cables and connectors.
1. Description
The very low noise preamplifier for COFDM signals offers its best performance with COFDM digital links. Also, it can be used with analogue links. This LNA is very useful for Broadcast applications and air links.
This equipment expands the possibilities of existing COFDM digital links, because with it, the noise figure of the receivers is improved. The selectivity is also increased and it compensates the attenuation caused by the coaxial cable between the antenna and the receiver.
It has two radiofrequency filters: one selective at the input with 5 poles, which enables it to work in the most adverse radiofrequency environments and other between the amplifier’s stages.
The COFDM low noise preamplifier uses PHEMT technology and 90º hybrid couplers to ensure excellent linearity. The third order intermodulation products (IP3) are +33 dBm, which means they have no problem working with strong COFDM signals modulated in 64QAM.
The LNA preamplifier for COFDM signals has an excellent noise figure and so, link sensitivity is increased, thus improving coverage and reliability.
It has a good input adaptation, eliminating undesired self-oscillations.
The LNA is powered through the output coax. For it, a bias insertion tee
(BIAS-TEE) can be used.
2. Technical Specifications
RF Specifications
Table 2.1 RF Specifications
Power Supply
Table 2.2 Power Supply Specifications
Consumption
Table 2.3 Consumption
Physical Characteristics
Table 2.4 Physical Characteristics
Environmental Conditions
Table 2.5 Environmental conditions
3. Electronics Diagram
Figure 3.1 COFRDM Low Noise Preamplifier’s electronics diagram
4. Frequency Response
Figure 4.1 COFDM Low Noise Preamplifier’s frequency response (1)
Figure 4.2 COFDM Low Noise Preamplifier’s frequency response (2)
End note
At SVP Broadcast Microwave S.L. we make a constant effort to continuously
improve our equipments and models. For that reason, please understand that
there may be some changes in design, equipment and technology. Therefore, we
cannot be held liable for the data, figures and descriptions given in this
datasheet.
The datasheet’s text, figures and standards are based on the information we had when the datasheet was published.
Reprinting, reproduction and translation of all or part of this datasheet is forbidden without written permission by SVP Broadcast Microwave S.L.
SVP Broadcast Microwave S.L. reserves all copyrights.
All right to make changes are reserved.
SVP Broadcast Microwave reserves the right to make changes to this user’s guide and the device without prior warning.
C/Zubiaurre 7 bajo
48215 Iurreta
Vizcaya – España
Tel-34-94620 3722
info@svpbm.com
www.svpbm.com
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>