Airmaker AM006 Air Foot Pump Black Powder Coated Body User Guide
- June 5, 2024
- Airmaker
Table of Contents
USER GUIDE
To Operate/Installation/Using Foot Pump
- Attach the pump hose (2) to the tube valve and Connect Push the tyre valve connector (Brass Nozzle (3) flip the thumb lockdown.
- Begin pumping by pressing down on the foot pedal (8).
- Monitor the pressure and make sure you do not overfill the tube with air. Do not exceed the recommended amount of PSI for your tyre. Your tyre’s PSI rating should be stamped on the sidewall in Your Pump’s Gauge (1).
- Remove the tyre valve connector (Brass Nozzle (3) from the tyre valve. Take care when removing the tyre valve connector (Brass Nozzle (3).
- To lock the foot pump in the closed position slowly push the footplate down & twist the fit up lock lever (6).
- Included with this Foot Pump, are various adaptors, to enable you to inflate other items to avoid over-inflation, always follow the manufacturer’s instructions on the items to be inflated. Sports Ball Adaptor (4) Cycle Nozzle for Bicycles Tyres (5)
Operating Features
- Analog Pressure Gauge.
- Heavy Nylon Braided Air Pressure Pipe. with 100cm. Length (Approx).
- Heavy Brass Nozzle for Car, Motorbike etc.
- Sports Ball Pin Adapter.
- Heavy Brass Cycle Nozzle for Bicycles.
- Lock for Rest of Pump.
- Heavy Powder Coated Cylinder.
- Heavy Cast Iron Foot Pedal.
- Powder Coated Frame.
- Rubber Cover for Gauge Safety.
- Extra Rubber Ring for Piston.
- Extra Rubber Bush for Heavy Brass Nozzle.
WARNING!/SAFETY MESSAGE!/CAUTION!
Please read the operating instructions carefully before using your foot pump. Improper use can cause damage to property and possibly harm the user. When using the foot pump ensure the vehicle is parked in a safe location, off the road with the vehicle handbrake on and where your personal safety is not at risk.
- Inspect before each use.
- Don’t allow children to use this foot pump.
- Correct tyre pressure is vital for road safety.
- Under or over inflated tyres can be dangerous.
- Always check pressures in an ambient temperature, never immediately after a long journey.
- Don’t kink or block the air hose when working.
- Don’t use the foot pump if bent, broken, melted, or any of the components are damaged.
- These Pumps in some parts maybe sharpness so uses carefully.
- Always wear shoes & safety glasses when using this foot pump.
- Failure to need these markings may result in personal injury or property damage.
MAINTENANCE
Periodically inspect the foot pump. Ensure that all parts move freely. Inspect the air hose for cracking and abrasions. Occasionally add a drop of motor oil to the pump piston.
CLEANING
Periodically inspect the foot pump for signs of rust or corrosion. If any rust spots are found, sand the affected area and cover with a suitable utility paint. Clean as needed and wipe with an oily cloth.
STORAGE
When not in use, store with pump piston fully retracted and foot pedal latched. Store indoors, do not expose to moisture or heat radiation.
Thank you for purchasing Foot Pump
We are a manufacturer of a broad range of Air Foot Pump & Spares Since 1990.
We provide these products with diverse specifications to attain the complete
satisfaction of the clients. We offer these products at reasonable rates and
deliver these within the promised time frame. Our company is located in Rajkot
(Gujarat, India).
Save these instructions for your safety. Read, understand, and follow the
information provided with this foot pump. The owner and the operator have to
understand safe operation procedures before use. The owner and the operator
shall be aware that the use of this product may require special skills and
knowledge. If the owner has any doubt about the safe and proper use of this
foot pump please remove it from service immediately. If you see any damaged
parts of this product so please do not use them. This Foot Pump is specially
designed for tyre, sports balls, and other products. Check proper information
of the product which concerns this foot pump for proper use.
FAQ
Pumping but the tyre is not inflating.
-Check that the tyre valve adaptor is correctly fitted to the tyre valve.
The gauge does not display when the tyre valve is connected.
-Ensure the tyre valve is correctly connected to the tyre valve adaptor.
Dear Sir/Madam
Thank you for choosing Foot Pump. It was wonderful serving you and we hope our
business with you grows and we continue to provide our best possible services
to you.
If you have any queries regarding your new purchase, you can write back to us
and we will help you resolve the same.
We request you to help us to serve you better by providing us with positive
feedback and rating us well. Thank you.
Team Foot Pump.
Follow us on
https://www.facebook.com/airmakerfootpump
Umakant Pandit Udyognagar, Rajkot-360 004. (Gujarat)
E-mail: airrnakerfootpump@gmail.com
Customer Care No.: +91-97243 27774
COPY RIGHT NO: A-585651® TRADEMARK REGISTERED NO: 864694
www.airmaker.co.in
Made in Bharat
Documents / Resources
|
Airmaker AM006 Air Foot Pump Black Powder Coated
Body
[pdf] User Guide
AM006, Air Foot Pump Black Powder Coated Body, AM006 Air Foot Pump Black
Powder Coated Body
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>