SEIZMIK 76-10166 Turbo-S 2 Seat Skid Plate Instruction Manual
- June 3, 2024
- SEIZMIK
Table of Contents
SEIZMIK 76-10166 Turbo-S 2 Seat Skid Plate
OVERVIEW
View looking up at the underside of the vehicle
Parts List
- GREEN holes use M6x25mm tapered bolt and washer into factory threaded holes
- BLUE holes use a bolt with wrap around clamp
- YELLOW holes use an M6x16mm bolt and washer into clip nuts attached to metal brackets.
- ORANGE holes use M6x25mm tapered bolt and insert washer placed into factory hole in sheet metal
- RED holes use Self Tapping Screws- Some locations may or may not require pre-drilling of a 1/8” pilot hole.
INSTRUCTIONS
- Uses OEM Threaded holes
- Uses Clamps
- 16mm bolt threads into brackets with clip nuts
- Uses insert washer into sheet metal hole
- Self Tapping Screws-May or may not require predrilling of 1/8” pilot hole.
- Uses OEM Threaded holes
- Uses Clamps
- 16mm bolt threads into brackets with clip nuts
- Uses insert washer into sheet metal hole
- Self Tapping Screws-May or may not require predrilling of 1/8” pilot hole.
- Attach all clip nuts to slotted holes in metal brackets.
- Threading should face upwards, toward a vehicle
Threading faces outward:
Insert Washer
- To start, remove the stock skid plate.
- Then, place insert washers (Shown in ORANGE) into holes in Sheetmetal. The side shown faces upwards, toward the vehicle.
- Snap clamps (Shown in BLUE) round metal tubing in the general location shown.
To start, loosely install the center tapered bolt and washer (Shown in GREEN)
and 2 self-drilling bolts and washers (Shown in RED) into pre-existing holes
so that the front panel is held in place on its own.
Next, loosely attach the metal brackets to the front panel using 4 bolts and
washers (Shown in YELLOW) into the clip nuts that you attached to the metal
brackets. The metal brackets go between the panels and the vehicle frame. The
panels will sandwich the brackets to the underside of the vehicle frame.
INSTRUCTIONS
NOTE: Spacer goes between vehicle and rear panel
NOTE: Spacer goes between vehicle and rear
panel
Always observe the warnings and precautions in this manual when using your
Seizmik products. For best results, carefully follow the instructions in this
manual and make no modifications. If you have any questions, or comments, need
assistance or are missing parts, please call
1-866-838-3366 between 9:00 AM and 5:00
PM EST. You can email us at
support@seizmik.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>