STERNGLAS ZEITMESSER Chrono Watch User Manual
- June 5, 2024
- STERNGLAS ZEITMESSER
Table of Contents
STERNGLAS ZEITMESSER Chrono Watch
How to setup your timepiece
- Remove the lock on the crown.
- Now you are ready to set the time. To do so, pull the crown to position 3 and turn until the hands are in the correct position.
- To set the date, push the crown in by one position so that it is in position
- Turn the crown clockwise until the correct date is displayed. Now you can push the crown back to the starting position (position 1).
Note: Your date changes at noon? This is because the movement does not
„know” if it is noon or midnight. If so, simply wind your timepiece forward by
12 hours.
Your chronograph can measure the time in 1-second units – up to 59 minutes and
59 seconds. Press button A to start and stop the timekeeping. When you press
button B, the chronograph second hand and chronograph minute hand return to
the zero position.
You would rather have a different strap on your timepiece? No problem, changing it couldn‘t be easier.
-
On the back of your strap, you will find a small metal pin. Slide this inward.
-
The band can then be easily detached from the watch case.
-
Now you can attach a new strap to your timepiece. To do so, do the same thing again: push back the metal pin and then release it to let the new strap snap into place. Make sure you attach the short side to the upper side of the watch. Final check: Is everything securely in place? Done.