Shenzhen Jos Technology JOSLMMAX Garage Door Remote Instruction Manual
- June 5, 2024
- Shenzhen Jos Technology
Table of Contents
Shenzhen Jos Technology JOSLMMAX Garage Door Remote
Remote Manual
-
Step 1: Confirm Color of Button
Check what color is the learn button behind the garage door opener -
Step 2:Programming Initiation
Press and Hold the III and II button at the same time till the led indicator flash 4 times and then release it
-
Step 3: Choose Code Type
Within 8 seconds, Press and Release the remote control button(one of the 3 buttons) you wish to use, times according to the color of your learn button and the following chart
For example: you want to set II button to be 315MHZ Security+ purple learning button , press and release II button 2 times, LED indicator light on and off, then press I or III button 1 time to fixed the II button code
-
Step 4: Garage Door Opener Learning
Press and immediately release the learn button, then learn LED will glow steadily for 30 seconds. Within 30 seconds… -
Step 5: Programming Complete
Press and hold the button on the remote control that you wish to use. Release the button when the garage door openers lights blink or two clicks are heard. If programming to other products, press the button a second time to activate the product.
FCC Statement
This device complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions: 1) this device may not cause harmful
interference, and 2) this device must accept any interference received,
including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined byturning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- reorient or relocate the receiving antenna.
- increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- consult the dealer or an experienced radio/TV technician for help. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Radiation Exposure Statement
This device complies with RF radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>