Shenzhen Jos Technology MC-803 Garage Door Remote Control Instructions
- June 5, 2024
- Shenzhen Jos Technology
Table of Contents
Shenzhen Jos Technology MC-803 Garage Door Remote Control
INSTRUCTIONS TO PROGRAM A REMOTE:
- Locate the garage receiver and determine the location of the LEARN button on your opener.
- Push the learn button on the opener. Light will blink.
- Press any button you wish to program on MC-803
- Light on opener will stop blinking.
- The remote is now programmed.
- Follow these same steps to program multiple openers to a multi-button remote.
- Step away from all moving parts and doors and test the function.
WARNING
In order to prevent possible SERIOUS INUURY or DEATH from a moving gate or
garage door keep remote controls out of the reach of children. Only use the
remote control when the gate garage door can be seen deary, is property
adjusted, and there are no obstructions to door travel. Keep the gate garage
door in sight until is completely closed.Do not allow anyone to cross paths
with the gate/garage door while moving or operating the remote control.
FCC Statement
This device complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions: 1) this device may not cause harmful
interference, and 2) this device must accept any interference received,
including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to corect the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment
Radiation Exposure Statement
This device complies with RF radiation exposure limits set forth for an
uncontrolled environment. This transmitter must not be co-located or operating
in conjunction with any other antenna or transmitter.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>