Roccat Elo 7.1 Air User Manual and Driver

June 5, 2024
ROCCAT

Roccat Elo 7.1 Air

QUICK START GUIDE

Download Driver

PACKAGE CONTAINS

PACKAGE CONTAINS

HEADSET CONTROLS

HEADSET CONTROLS

LED INDICATIONS

LED INDICATIONS

CHARGING

CHARGING

The Elo 7.1 Air uses a 24+ hour rechargeable battery. Make sure to charge it regularly.

Headset Storage

Always charge your headset before storing it for any extended period of time (greater than 3 months). Never store the unit in temperatures above 113°F/45°C

USB-A COMPATIBILITY

USB-A COMPATIBILITY

The ELO 7.1 Air also works great with other platforms with USB-A ports, including the PS5 & PS4 and Nintendo Switch, in docked mode.

  1. Plug the Transmitter in a USB-A on your device
  2. Hold the Power Button for 2 seconds to turn on the headset
  3. In your device’s settings, make sure the Elo is selected on your device.

When connecting the transmitter to a PS5 or PS4, master volume must be adjusted from the Settings Menu.

*Software capabilities are only available on PC.

PC/MAC® SETUP

PC/MAC® SETUP

  1. Plug the Elo 7.1 Air Transmitter in a USB slot on your PC
  2. Hold the Power Button for 2 seconds to turn on the headset (the transmitter and headset are automatically paired)
  3. Right click the speaker icon in your toolbar and select “Open Sound Settings”
  4. Select “Elo 7.1 Air” from the “Choose Your Output Device” drop-down menu
  5. Open the driver software to customize your settings

TECHNICAL FACTS

TECH SPECS

  • Direct wireless connection via USB-A transmitter 20Hz – 20kHz speaker frequency response
  • 2.4GHz transmitter frequency response
  • Audio controls: power button, master volume wheel, mic mute, mic monitor wheel
  • Rechargeable 24h battery (average 1+ week play time based on typical ~3h use per day)
  • 50mm speakers with neodymium magnets Removable unidirectional microphone
  • Leatherette headband with foam cushioning
  • Over-ear design featuring memory foam

SYSTEM REQUIREMENTS

  • Windows® 7, 8 and 10 (software support)
  • USB 2.0 (or higher)
  • Internet connection (for driver software)

Should you need assistance …
Our support team is ready to help you with any technical questions. Just send an e-mail to support@roccat.com or visit our website at:
WWW.ROCCAT.COM/SUPPORT

REGULATORY COMPLIANCE STATEMENTS FOR THE ELO 7.1 AIR RX & TX
LOCAL RESTRICTIONS ON RADIO USAGE

Caution: Due to the fact that the frequencies used by wireless devices may not yet be harmonized in all countries, these radio products are designed for use only in specific countries, and are not allowed to be operated in countries other than those of designated use. As a user of these products, you are responsible for ensuring that the products are used only in the countries for which they were intended and for verifying that they are configured with the correct selection of frequency and channel for the country of use. Any deviation from the permissible power and frequency settings for the country of use is an infringement of national law and may be punished as such.

To determine whether you are allowed to use your wireless network device in a specific country, please check to see if the radio type number that is printed on the identification label of your device is listed in the manufacturer‘s OEM Regulatory Guidance document at the following URL http://www.turtlebeach.com/homologation or contact Turtle Beach directly.

FEDERAL COMMUNICATIONS COMMISSION (FCC) COMPLIANCE NOTICES

This section includes the following FCC statements for the Elo 7.1 AIR:

  • FCC IDs: XGB-TB18140 & XGB-TB15143
  • Class B Interference Statement
  • RF Radiation Exposure & Hazard Warning
  • Non-Modification Statement

CLASS B INTERFERENCE STATEMENT

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

FCC CAUTION:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

RF RADIATION EXPOSURE & HAZARD STATEMENT
To ensure compliance with FCC RF exposure requirements, this device must be installed in a location such that the antenna of the device will be greater than 2 cm (0.8 in.) from all persons. Using higher gain antennas and types of antennas not covered under the FCC certification of this product is not allowed. Installers of the radio and end users of the product must adhere to the installation instructions provided in this manual. This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.

NON-MODIFICATION STATEMENT
Use only the supplied internal antenna. Unauthorized antennas, modifications, or attachments could damage the Elo 7.1 AIR RX & TX Models and violate FCC regulations. Any changes or modifications not expressly approved by the party responsible for compliance could void the user‘s authority to operate this equipment. Please contact Turtle Beach for a list of approved 2.4 GHz antennas.

This product is compliant with the Consumer Product Safety Improvement Act of 2008, Public Law 110-314 (CPSIA)

CANADIAN ICES STATEMENTS
IC: 3879A-TB18140 & 3879A-TB15143
This device complies with ICES-003 and RSS-247 of Industry Canada.

Operation is subject to the following two conditions:

1. This device may not cause interference, and
2. This device must accept any interference, including interference that may cause undesired operation of the device.

This equipment complies with Industry Canada radiation exposure limits set forth for an uncontrolled environment.

To prevent radio interference to the licensed service (i.e. co-channel Mobile Satellite systems) this device is intended to be operated indoors and away from windows to provide maximum shielding. Equipment (or its transmit antenna) that is installed outdoors is subject to licensing and not supported by Elo 7.1 AIR RX & TX Models.

RF RADIATION EXPOSURE & HAZARD STATEMENT
To ensure compliance with RSS-102 RF exposure requirements, this device must be installed in a location such that the antenna of the device will be greater than 2 cm (0.8 in.) away from all persons. Using higher gain antennas and types of antennas not covered under the IC certification of this product is not allowed. Installers of the radio and end users of the product must adhere to the installation instructions provided in this manual. This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.

EUROPEAN UNION AND EUROPEAN FAIR TRADE ASSOCIATION (EFTA) REGULATORY COMPLIANCE

This equipment may be operated in the countries that comprise the member countries of the European Union and the European Fair Trade Association. These countries, listed below, are referred to as The European Community throughout this document:

AUSTRIA, BELGIUM, BULGARIA, CYPRUS, CZECH REPUBLIC, DENMARK, ESTONIA, FINLAND, FRANCE,, GERMANY, GREECE, HUNGARY, IRELAND, ITALY, LATVIA, LITHUA-NIA, LUXEMBOURG, MALTA, NETHERLANDS, POLAND, PORTUGAL, ROMANIA, SLOVAKIA, SLOVENIA, SPAIN, SWEDEN, UNITED KINGDOM, ICELAND, LICHTENSTEIN, NORWAY, SWITZERLAND

Declaration of Conformity

Marking by this symbol: CE indicates compliance with the Essential Requirements of the EMC Directive of the European Union (2014/30/EU). This equipment meets the following conformance standards:

Safety: EN 60950-1:2006 + A11:2009 + A1:2010 + A12:2011 + A2:2013(T-Mark License), IEC 60950-1:2005 (2nd Ed.) + Am 1:2009 + Am 2:2013 (CB Scheme Certificate), IEC 62368-1:2014,
EN 50332-1:2013, EN 50332-2:2013, EN71-3:2013

EMC: EN 55032:2015; CISPR 32:2015, EN 301489-1 V2.1.1(2017-02), EN301489-17 V3.1.1(2016-11)

Radio: EN 300328 V2.2.2

SAR: EN 62311:2008

Environmental: RoHS 2015/863 amending Annex II to 2011/65/EU, WEEE 2012/19/EU, REACH 2006/1907/EC, Packaging 94/62/EC, Battery 2006/66/EC, Toys Safety Directive 2009/48/EC

Please visit the following URL for a complete copy of the Declaration of Conformity: http://www.turtlebeach.com/homologation

Warning: To prevent possible hearing damage, do not listen at high volume levels for long periods.

Warning!
This is a Class B product. In a domestic environment, this product may cause radio interference, in which case, the user may be required to take appropriate measures.

This symbol on the product or its packaging indicates that this product must not be disposed of with your other household waste. Instead, it is your responsibility to dispose of your waste equipment by handing it over to a designated collection point for the recycling of waste electrical and electronic equipment. The separate collection and recycling of your waste equipment at the time of disposal will help conserve natural resources and ensure that it is recycled in a manner that protects human health and the environment. For more information about where you can drop off your waste for recycling, please contact your local authority, or where you purchased your product.

Turtle Beach Europe Ltd is obligated as a producer with a main activity of selling under The Producer Responsibility Obligations (Packaging Waste) Regulations 2007. To fulfil our obligation we are registered with Comply Direct and their Recycling Room. Here you will find advice and information on packaging waste management, recycling symbols and the waste hierarchy principles of reduce, reuse and recycle.
https://www.complydirect.com/the-recycling-room/

VOYETRA TURTLE BEACH, INC. | 44 SOUTH BROADWAY, 4TH FLOOR, WHITE PLAINS NY 10601, USA
© 2021 Voyetra Turtle Beach, Inc. All rights reserved. Any product names mentioned in this manual may be trademarks or registered trademarks and are the property of their respective owners. Information contained herein is subject to change without notice. Voyetra Turtle Beach, Inc shall not be made liable for any errors that may appear in this manual. This publication or parts of it may not be reproduced without the express consent of the publisher.

TO ACCESS THE RATING LEVEL

  1. Remove the left ear pad by pulling the ear pad straight up using your thumb.

2. Once you have relies the cloth from the lip on top, pull the ear pad straight back and it should slip right off.

To replace the ear pad, follow the same process in reverse.

Release Date: 2022-04-05

Driver Version: 1.9403

Operating systems:

Windows® 11

Windows® 10 64 Bit

Windows® 10 32 Bit

Windows® 8.1 64 Bit

Windows® 8.1 32 Bit

Windows® 8 64 Bit

Windows® 8 32 Bit

Windows® 7 64 Bit

Windows® 7 32 Bit

WWW.ROCCAT.COM


DOWNLOAD

Roccat Elo 7.1 Air User Manual – [ Download PDF ]

Roccat Elo 7.1 Air Driver – [ Download Driver ]


Read User Manual Online (PDF format)

Loading......

Download This Manual (PDF format)

Download this manual  >>

Related Manuals