Shenzhen Suncent Auto Parts Technology SL9CIL19600 Device User Manual

Sunset Auto Parts Technology SL9CIL19600 Device
User Manual

Thank you very much for purchasing SEALIGHT. This is a Rock light. With the APP that comes with the product, users are able to get the colors they want.

Restrictions and guidelines

1. Do not install the Rock light near water or in a corrosive location.
2. Do not trample or violently strike the light sets during installation.
3. Bind the LED strip securely to prevent them from being trapped in the transmission shaft or tires.

Contents

Parameters:

Download App:

1. Download the App Hostrol smart from the App store (iOS device) or Google Play (Android device).
   Tips: This App is compatible with iOS 9.0 and above, and Android 5.0 and above.

2. Turn on the Bluetooth on your device.

3. Click Add Device and follow instructions.

Steps

1. Verify the contents and accessories in the kit.
2. Connect the interfaces on the control box and light sets, and then connect them to the vehicle power supply to verify whether the light sets work and APP can be operated by the remote controller normally.
3. Disconnect the control box and the light sets, and secure the connecting box in place (with cable ties).
4. Clean the position for Rock light installation and measure the locations of holes on the light sets. Secure the light sets with screws, nuts and washers for each hole. A cable hole shall be drilled to conceal the cables and wires.
5. Tighten the light set wires and control box outgoing wires and conceal them in a hidden place. (Do not put them over the engine or suspensions to prevent damage.)
6. Fix the spare cables and wires of the Rock light on the sidebars with cable ties (at hidden places to prevent them from being trapped in the transmission shaft or tires).

Using the strip lightly with remote

FAQs:

1. No light: Check whether the light is properly wired and the interface is tightly inserted.
2. Bluetooth connection fails: Make sure that the Bluetooth on your phone is on.
3. Compatibility error. Please replace a new phone or upgrade your phone system.
4. Keep the light sets within 2m.
5. For any questions, please contact our after-sale services.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
FCC ID: 2A4IR-SL9CIL19600 Phone number1805538-4353 Mon-Fri 9 am -5pmPST
Website https://sealight-led.com/
Email support@sealight-led.com
MADE IN CHINA

References

• LED Commercial Lighting and Lighting Controls | Current - GLI Brands
• SEALIGHT Auto Parts & Equipments

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>