keji COKW05BKR Wireless Charging Pad User Manual
- June 5, 2024
- keji
Table of Contents
keji COKW05BKR Wireless Charging Pad
Compatibility
Compatible with Qi-enabled devices* including
- iPhone 11 Pro/11
- iPhone XS/XS Max/XR
- iPhone X/8/8 Plus
- Samsung S10/S9/S8/S7
- Samsung Note 10/9/8/5
- Sony Xperia XZ3/XZ2
- Google Pixel 4/4 XL/3/3 XL
- Xiaomi Mi 9/Mi Mix 3
- Huawei Mate 30/20 Pro
- Huawei P30 Pro
- LG G8S/G7 ThinQ
- LG V30+/V40
Features
- Supports 5W standard wireless charging for all Qi-enabled devices
- No need to remove your protective case. Works with most cases up to 3mm thick
- LED indicator to show charging status
- Smart IC enables energy-saving mode when the device is fully charged
- Full safety protection for your devices with temperature control, voltage regulation & short circuit protection
- Includes 1.5m USB-A to USB-C cable to connect charging pad to USB wall charger (USB wall charger not included)
Wireless Charger Operation
- Using the included USB-A to USB-C cable, connect the wireless charging pad to a USB wall charger (USB wall charger not included)
- It is recommended to use original or reputable 3rd party-branded USB wall chargers. For faster charging times it is recommended to use a USB wall charger with a minimum of 2A output
- When connected to the USB charger, the LED will light RED to indicate the charging pad is powered on and in stand-by mode
- Place your Qi enabled wireless phone on the charging pad and you phone should start charging automatically
- The LED will be blue to indicate charging
- If your phone does not start charging, move your phone until the correct position is found and your phone starts charging
- When your phone is fully charged, the Smart IC enables energy-saving trickle charge mode
Specifications
- Wireless Standard: WPC/Qi (v1.2.4)
- Quantity of Wireless Charging Coils: Single Coil
- Input: DC 5V 2A
- Wireless Output: 5W
- Working Frequency: 110 to 205KHz
- Charging Distance: 3 to 8mm
- Charging Efficiency: >72%
- Dimensions: 99 x 99 x 6.2mm
- Weight: 65g
Important Safety Instructions
- Only use original or reputable third-party chargers and cables
- Do not get wet to avoid causing short circuit damage and leakage
- Do not use in extremely hot, humid or corrosive environments to avoid short circuit damage and leakage
- Do not place too close to magnetic strip or chip ID card to avoid magnetic failure
- Do not place within 20cm of implantable medical devices (pacemaker, cochlear implant, etc.) to avoid potential interference
- Do not clean with harmful chemicals or detergents
- Misuse, dropping or excessive force may cause damage to the charging stand
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>