jason L Switch System Single Desk Installation Guide
- June 3, 2024
- Jason L
Table of Contents
jason L Switch System Single Desk
Tools Required:
Power screwdriver.
Note:
Please ignore any pre-drilled holes or nut inserts that maybe present in your
top(s). They will not match your particular table/desk base and woods screws
will be required to be screwed directly into the underside of the top.
Note:
It is important to fully tighten all bolts and screws before attaching the
top(s) so that the frame is sufficiently rigid. Failure to do this may affect
stability once the tops are attached.
COMPONENTS
- Table Top (1600x700mm)
- Leg x4
- Leg Bracket x4
- Beam Bracket x8
- Long Beam x2 (1125mm)
- Short Beam x2 (225mm)
- L-Bracket x10
SCREWS
- Hex Nut x4
- L-Bracket screws x10
- Hex Head screws x16
- M8x25mm Dome Head x4
Instruction
Join Leg Brackets to each Leg using screws to secure them, as follow. ****
Join 3 L-Bracket through each Long Beam and 2 L-Bracket through each Short Beam.
Securely connect each Beam to each Beam Bracket. Screw to secure.
Insert Hex Nut on each Beam Bracket.
Position as presented, and proceed to screw to ensure each corner of the frame.
Directly screw into table tops, using L-Bracket screws through each L-Bracket.
If this bolt does not drop into the joint use the Allen key to screw it all the way in so that it creates its own thread. This will ensure a nice, tight joint.
Note:
It is important to fully tighten all bolts and screws before attaching the
top(s) so that the frame is sufficiently rigid. Failure to do this may affect
stability once the tops are attached.
Contact Us
www.jasonl.com.au
Need help!
Call us on
1300 527 665
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>