enviolo AUTOMATIQ Wireless Controller Installation Guide
- June 5, 2024
- enviolo
Table of Contents
enviolo AUTOMATIQ Wireless Controller
CO Controller Installation
This guide shows how to add the CO Controller or handlebar-mounted controller
to the handlebar of your EVELO Electric Bicycle. This applies to models
equipped with the Enviolo Automatic CVT shifting system.
Note: There is no digital display on the shifter itself. You will see a
flashing LED light as a power and pairing indicator. Please see the CO
Controller guide for more detailed information.
- Step 1: The handlebar-mounted controller attaches to the right side of the handlebar – make sure this area is clear of any other installed accessories.
- Step 2: Locate the hex bolt on the bottom of the handlebar controller.
- Step 3: Rotate counterclockwise until it is fully removed – do not lose this bolt.
- Step 4: With this bolt removed, the hinge at the bottom will open.
- Step 5: Place the handlebar controller on the bicycle handlebar.
- Step 6: Insert the hex bolt removed in Step 3 and rotate clockwise until the controller is snug, but not fully tight.
- Step 7: Rotate the controller on the handlebar and adjust for a comfortable position to press the buttons while riding. This can be adjusted again at a later time. Use the hex wrench to fully tighten the handlebar controller so it does not move while riding.
- Step 8: Your completed installation should match this photo for optimal operation.
Questions? Get In Touch:
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>