KOMA EA1305 Wireless Car Charger User Manual

KOMA EA1305 Wireless Car Charger

Thank you for purchasing and using this product!
Please read this operating instruction carefully and keep it properly before using this product.

Product Specification

• Fast Wireless Car Charger
• Input: 5V 2A/9V- 2A
• Output: 5W/ 7.5W/ 10W
• Charging Efficiency: 70%
• Working frequency: 110.5K-205K

AThe LED light turns red during wireless charging to indicate a charging failure.
The following situation can cause failures, like charging slowly, stop charging, and over-temperature for charging position.

1. The adapter is not run up to standard.
2. The charging cable is not up to standard.
3. The phone case is too thick (within 3mm thickness phone case recommended ).
4. There is metal on the back of the cell phone or phonecase.
5. Smartphone does not support wireless charging functions.

Attention

1. Please keep the charger away from water or other liquid.
2. If you need to dean the charger, please make sure it is not connected to the power supply.
3. Using Environment temperature remains-20-45 C.

Auto-Clamping Mode

1. As shown by the arrow, push the bottom bracket forward to enter the auto-clamping mode,the right and left clamping arms open automatically.
2. The charging coil can auto-sense and auto-move to the correct position for wireless charging of the phone based on different mobile phone sizes.

MagSafe Mode

1. As shown by the arrow, push the bottom bracket back to enter Mag Safe mode, the left and right clamping arms close automatically.
2. The coil auto-move to the top of position MagSafe mode charging, compatible with iPhone13 & iPhone12 series only.

Take off smartphone
Press the key, the clip opens automatically, and take your phone out.

LED andica tor light show s the work in g sta tus

1. Blue Light ON Working:
2. .Red Light ON Stand by
3. Red Light Flashing Error

Step to installairvent

1. Follow the arrows to install 3 parts

2. Adjust the screw cap to the best active status.

3. 3.Installation completed.

Step to install suctioncup

1. Follow the arrows to install 3 parts.
2. Adjust the screw cap to the best active status
3. Paste the suction cup on the dashboard.
4. Paste the support frame to the appropriate position
5. Installation completed.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>