ROWENTA SO9055F0 Turboceram Energy Smart User Manual

: June 5, 2024
: Rowenta

Table of Contents

ROWENTA SO9055F0 Turboceram Energy Smart
OVERVIEW
WARNINGS
VERY IMPORTANT
SAFETY
OPERATION
CLEANING
STORAGE
IN THE EVENT OF PROBLEMS
ENVIRONNEMENT PROTECTION FIRST!
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

ROWENTA SO9055F0 Turboceram Energy Smart

OVERVIEW

ROWENTA-SO9055F0-Turboceram-Energy-
Smart-1

A. Control panel
B. On/Standby (stop) button
C. Standby indicator
D. Air intake grille
E. Removable, washable filter protecting the air inlet grille
F. Air outlet grille
G. Carry handle

WARNINGS

For your safety, this appliance complies with the applicable standards and regulations or commercial (Low Voltage, Electromagnetic Compatibility, Environmental Directives, etc.)
The warranty will be invalid in the event of damage arising from incorrect use.
Do not place your appliance directly beneath a wall socket.
Do not operate your appliance in a dusty room or if there is a risk of fire.
Each time before use, check that in general the appliance is in good condition, as well as the plug and the cord.
Never insert any objects inside the appliance (e.g.: needles)
If the power cord is damaged, it must be changed by the manufacturer, the After Sales Service or a similarly qualified person in order to avoid any danger.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.
Do not pull the power cord or the appliance, even to unplug it from the wall socket.
Completely unwind the cord each time before use.
This product has been designed for domestic use only. Any commercial use, inappropriate use or failure to comply with the instructions, the manufacturer accepts no responsibility and the guarantee will not apply.

VERY IMPORTANT

WARNING: IN ORDER TO AVOID OVERHEATING DO NOT COVER THE HEATER
Do not touch the appliance with wet hands.
Do not let water get into the appliance.
Do not use this appliance near baths, showers, sinks or swimming pools.
Do not use the appliance near inflammable objects and products (curtains, aerosols, solvents, etc.).
Do not use the appliance when tilted or laid flat.
In the event of prolonged absence: stop the appliance using button B and unplug.
However, the electrical installation in the room, the installation of the unit and the way the unit is used must all comply with the safety standards in force in your country.
Do not use the appliance in damp places.

VOLTAGE

Before first use, make sure that the voltage being used corresponds to what is indicated on the unit and that the electrical installation is adapted to the power level indicated.
Your appliance can be used with a power plug without an earth connection. It is a class II appliance (double insulation

SAFETY

In the event of abnormal overheating, a safety device shuts down the appliance and then automatically restarts it once it has cooled. If the fault persists or gets worse, a thermal fuse shuts the appliance down completely and it must then be taken to an approved service centre.

OPERATION

Before turning the unit on, make sure:

it is positioned as described in these instructions,
that it is placed on a flat and horizontal surface, and;
that the air intake and outlet grilles are free of all obstacles.

When the appliance is connected to the mains electricity (plugged in), it is in “STANDBY” mode (Stop), indicator C is lit; electrical consumption of the appliance in standby is then less than 0.5W.
The appliance will emit a sound signal each time the control buttons are used.

Display A1: Room temperature at the appliance.
Display A2: Selected temperature.
A3 buttons: temperature selection (in SILENCE and MAX functions).
Button B “STANDBY”: On / Standby This button enables you to activate the appliance or switch to standby. A cooling cycle lasting for a few seconds is automatically activated before the appliance switches off; the button will flash during this cooling cycle.
Button A4 “Cool Fan”: Cold ventilation setting This setting enables you to use your fan heater as a cooling fan in summer.
Button A5 “SILENCE”: 1000W regulated “Silence” setting This setting enables you to automatically maintain the room temperature at the tempera-ture you have selected using the + and – buttons (in a normally insulated room whose volume corresponds to the power of this function).
Button A6 “MAX”: 2000W regulated setting This setting enables you to automatically maintain the room temperature at the temperature you have selected using the + and – buttons (in a nor-mally insulated room whose volume corresponds to the power of this function).
Button A7 “ECO ENERGY Function”: 1000W SILENCE automatically set at 21°C This setting enables you to automatically set the room temperature at 21°C on a half-power setting (1000W) in order to avoid excessive consumption.

NOTE: To improve temperature control, the ventilation of your appliance will function for a few seconds per minute during the temperature regulation deactivation cycles.

CLEANING

Your appliance must be unplugged before proceeding with any cleaning work.
You can clean it with a slightly damp cloth.
IMPORTANT: Never use abrasive products which might damage the appearance of your appliance.
Your appliance is fitted whith a removable and washable dust filter (soap and warm water), which has to be cleaned regularly (Fig. 4a and 4b).
Always ensure that the filter is thoroughly dry before replacing it.
Never use the appliance without its filter.

STORAGE

It is extremely important that the unit be allowed to cool down before it is put away.
When you are not using your appliance, store it in a dry place.

IN THE EVENT OF PROBLEMS

Never dismantle your appliance yourself. A poorly repaired appliance may be dangerous for the user.
Before contacting one of our Approved Service Centres, ensure that:
- the appliance is set to normal operating mode;
- the air inlet and outlet grilles are totally clear.