hama 00205291 SAT Finder with Analogue Display Instruction Manual

June 5, 2024
Hama

hama 00205291 SAT Finder with Analogue Display

hama-00205291-SAT-Finder-with-Analogue-Display-product

 Operating instruction

Thank you for choosing aHama product.
Take your time and read the following instructions and information completely.Please keep these instructions in asafe place for future reference. If you sell the device, please pass these operating instructions on to the new owner.

Package contents

  •  Satellite receiver finder with analogue display
  • Quick-F cable 10cm
  • These operating instructions

Safety instructions

  •  Protect the product from moivsture.
  •  Donot leave the SAT finder permanently installed between the SATdish and receiver.
  •  When working in the roof area, be awareofsafety regulations (danger of falling). If in doubt, contact aqualified expert and do not attempt to install it yourself!
  •  This product is intended for private, non-commercial use only.
  •  Use the product only for the intended purpose.
  •  Protect the product from dirt, moistureand overheating and use it in dry environments only.
  •  Donot use the product in the immediate vicinity of heaters, other heat sources or in direct sunlight.
  •  Only use the article under moderate climatic conditions.
  •  Aswith all electrical products, this device should be kept out of the reach of children.
  •  Donot drop the product and do not expose it to any major shocks.
  •  Donot modify the product in any way.Doing so voids the warranty.

Adjusting the SAT system to the best possible reception withthe SAT Finder

  •  Disconnect the SATreceiver from the power supply and connect the SAT Finder as shown in the illustration with ashort F-plug cable between the LNB and receiver.

  •  Connect the receiver back to the power supply and select aprogram slot.

  •  Adjust the sensitivity regulator (1) until the level drops.

  •  Set the SATaerial (SATdish) roughly to the desired satellites using
    the protractor and compass. Find the right satellites by turning and swivelling the SATaerial.

  •  The stronger the incoming SATsignal, the higher the measuring tone sounds. At the same time, the level (needle) on the signal strength display (2) increases from weak „1“ through medium to strong „10“.

  •  When the level shows the maximum „10“, the sensitivity regulator (1) is turned back until the level shows „reduced“ again.

  •  Now finely adjust the antenna to achieve the maximum value of „10“ again.

  •  Attaching the aerial fastenings with screws.

  • ATTENTION: Tightening the screws can change the set value again.

  •  Check on your receiver whether you can still receive the satellite you want.

  •  You can now remove the SATFinder and reconnect the LNB and receiver.

Warranty disclaimer
Hama GmbH &CoKGassumes no liability and provides no warranty for damage resulting from improper installation/mounting, improper use of the product or from failuretoobserve the operating instructions and/or safety notes.

Technical data

Frequency range: 950-2400 MHz

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals