IKEA Jetstrom LED Wall Light Panel Instruction Manual
- June 5, 2024
- Ikea
Table of Contents
**IKEA Jetstrom LED Wall Light Panel Instruction Manual
**
Product Instruction
Getting started
Connect your product to the mains or plug the power cable into the wall socket.
Before you can use your light source you’ll need to pair it with a steering device.
- Make sure that your light source is installed and the main power switch is turned on.
- Hold the steering device close to the light source you want to add (no more than 5 cm away).
- Press and hold the pairing button ****for at least 10 seconds. A red light will shine steadily on the steering device. Your light source will begin to dim and finally flash one time to indicate that it has been successfully paired.
Up to 10 light sources can be paired with 1 steering device. Make sure to pair them one at a time. If the light sources are close to each other, disconnect those that have already been paired from the main power switch.
With the remote control you can switch between 9 colours and white lights. With the IKEA smart hub and the IKEA Home smart app, you get a total of 20 colours and white lights.
If you have the TRÅDFRI gateway or DIRIGERA hub
Go to App Store or Google Play and download the IKEA Home smart app. The app
will take you through the process of installing your product and other
devices.
CAUTION:
DO NOT USE WITH STANDARD DIMMERS. This light source will not operate properly
when connected to a standard (incandescent) dimmer or dimming control. Only
controllable by IKEA Smart lighting products.
How to factory reset your product
If the product does not respond or if you want to un-pair the product from a
steering device you might have to make a factory reset. The product is forced
to factory reset by carefully inserting a paper clip end or similar in the
small hole (marked RESET) and apply a slight pressure.
IMPORTANT!
- For indoor use only.
- Do not leave the product in direct sunlight or near any heat source, as it may overheat.
- The declared radio range between the unit and the steering device is measured in open air.
- Different building materials and placement of the units can affect the wireless connectivity range.
Care Instructions
Wipe clean with a damp cloth. Never use abrasive cleaners or chemical solvents
as this can damage the product.
Save these instructions for future use.
Technical data:
Type: L2205, L2206 JETSTRÖM
Input: 220-240 VAC, 9.5W
Max lumen output: 1150 lm
Radio range: 10 m in open air.
Operating frequency: 2405-2480 MHz
Output power (EIRP): Max 8.5 dBm
Manufacturer: IKEA of Sweden AB
Address: Box 702, SE-343 81 Älmhult, SWEDEN
The crossed-out wheeled bin symbol indicates that the item should be
disposed of separately from household waste. The item should be handed in for
recycling in accordance with local environmental regulations for waste
disposal. By separating a marked item from household waste, you will help
reduce the volume of waste sent to incinerators or land-fill and minimize any
potential negative impact on human health and the environment. For more
information, please contact your IKEA store.