TOPDON AD 600 Full OBD2 Diagnostic Scanner Tool Code Reader User Guide
- June 5, 2024
- TOPDON
Table of Contents
- Charging LED
- 5-inch Touch Screen
- 5V DC Charging Port
- DB-15 Diagnostic Connector
- Power/Screen Lock Button
- HOME Button
- Selection Buttons
- OK Button
- Return Button
Register & Upgrade
– A stable and solid Wi-Fi network is required.
– Press the power button for 5 seconds to launch ArtiDiag600, and make some
system settings prior to the initial use.
– If ArtiDiag600 fails to turn on, use the included power adapter to charge
the unit.
Follow the steps on the right to proceed.
Preparation
– The ignition is turned on.
– The vehicle battery voltage is 9~18 volts.
– The throttle is in the closed position.
Start Diagnostics
– Locate the vehicle’s DLC port for OBDII connection.
– Connect ArtiDiag600 to the vehicle’s DLC port.
– ArtiDiag600 is ready to use.
IMPORTANT: Read the instruction carefully before operating.
Failure to do so may cause damage and/or personal injury.
NOTE: This Quick Start Guide is subject to change without written notice.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>