OMNIKLAD WLS-A07-01 Wireless Charging Stand User Manual
- June 5, 2024
- OMNIKLAD
Table of Contents
User Manual
Thank you for choosing our Omniklad Wireless Charge.
To ensure optimal performance from this product, please read this user manual
carefully and keep it safe for future reference, along with your receipt.
Safety Guidelines
Do not disassemble the product in an attempt to modify, repair, or for any
other purpose.
Do not store in high temperatures such as intense sunlight or other forms of
heat.
Do not place any magnetic strip cards or similar items (e.g. credit cards, ATM
cards, boarding passes, etc.) near this product as the magnetic data on this
product may get damaged.
Do not drop, knock, or shake this product. Keep your product in a dry area.
Humidity and liquids may damage the parts or electronic circuits.
Use the original or a certified cable only.
Product Featured
What’s inside
Operating Instructions
Plug-in DC adapter to the wireless charger using the cable provided. When the charger is turned on, the charger is turned on, the LED light will flick alternately in white for 2S then go off.
Wireless Charge
Place your device on the center of the charging plate. The white light stays
on white charing. If the device deviates from the center of the product, the
wireless charging function may be affected.
Wireless Charging Stand:
All devices are supported in both vertical and side charge.
LED Behavior:
A. While powered up but not charging: LED off
B. While powered up and charging: LED on
C. While powered but in FOD/ Error/ Fault condition: LED Blinks (@ 1.0Hz)
-The blinking sequence is 0.5 sec on, then 0.5-sec off
-Blinking continues while fault condition exists.
Notes
- Max 15W
- Compatible with 7.5W Quick Charger
- The Omniklad Wireless Charger is engineered to work with the most lightweight smartphone cases. However, if the back of the smartphone case is thicker than 3mm or
contains metallic, magnetic, or battery materials, which may affect the functionality of the wireless charger.
Product Specification:
Model: WLS-A07-01
Adapter Input:DC19V–1.58A
Adapter Input:Output (Wireless): 5W & 7.5& 10W & 15W
FCC
This device complies with part 15 of the FCC Rules. Operations are subject to
the following two conditions : ( 1 ) This device may not cause harmful
interference, and ( 2 ) this device must accept any interference received,
including interference that may cause undesired operation. This equipment has
been tested and found to comply with the limits for a Class B digital device
pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential
installation. This equipment generates, usesInd can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures: Reorient or relocate the receiving antenna. Increase the
separation between the equipment and receiver. Connect the equipment into an
outlet on a circuit Kieren from that to which the receiver is connected.
Consult the dealer or an experienced radio / TV technician for help.
CAUTION: To comply with the limits of the Class B digital device,
pursuant to Part 15 of the FCC Rules, this device must be used with certified
peripherals and shielded cables. All peripherals must be shielded and
grounded. Operation with non-certified peripherals or non-shielded cables may
result in interference to radio or reception. Caution: Any changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>