PAPERANG P2Z5 Thermal Printer User Manual
- June 5, 2024
- PAPERANG
Table of Contents
- PAPERANG P2Z5 Thermal Printer User Manual
- Replace consumables
- PAPERANG
- Product Introduction I Instructions
- Product Introduction App Download
- Product Introduction I Product Information
- Safety and Attention
- Battery overheating
- Bum hazard
- FCC COMPLIANCE STATEMENT:
- FCC Radiation Exposure Statement
- Read More About This Manual & Download PDF:
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
PAPERANG P2Z5 Thermal Printer User Manual
Replace consumables
- As shown, Push open the cover
- Place the paper roll in the direction as shown in figure
- Close the cover properly
PAPERANG
Connection Make sure the Bluetooth is on
- Method 1: Click connect device in APP to connect printer
- Method 2: After double clicking the power key Print out the QR code Scan code to connect to the printer.
Product Introduction I Instructions
Turn On/Off
- Press and hold the power key for 3 seconds Turn on when the light comes on
- Press and hold the power key again for 3 seconds Turn off when the light goes off
Product Introduction App Download
Install Paperang App on Your Mobile Device
Product Introduction I Product Information
- Power key
- Reset key
- Micro USB
Safety and Attention
Battery overheating
Battery management and precautions
- When charging is complete, we suggest unplugging the charging cable.
- To avoid the risk of fire, please do not charge in high temperature environments (such as steam rooms, near a campfire, etc.).
Attention when using
Charger Print head management and precautions
- The print head may be damaged by improper charging
- We recommend not to use the machine in high humidity or dusty environments
Bum hazard
Overheated print head
- After Printing Do not touch the print head directly
To prevent overheating and scalding
FCC COMPLIANCE STATEMENT:
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Note: This
equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential instalation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used In accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that Interference will not occur In a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures: Reorient or relocate
the receiving antenna. Increase the separation between the equipment and
receiver. Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected. Consult the dealer or an experienced
radio/TV technician for help.
Warning: Changes or modifications to this unit not expressly approved by the
part responsible for compliance could void the user’s authority to operate the
equipment.
FCC Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>