Xiamen Paperang Technology P1A1 Thermal Printer User Manual

Xiamen Paperang Technology P1A1 Thermal Printer

Product Introduction

• PAPERANG printer
• Thermal paper
• Charging Cable
• Manual
• Power key
• Micro USB
• Reset key

Turn On/Off

• Press and hold the power key for 3 seconds Turn on when the light comes on.
• Press and hold the power key again for 3 seconds turn off when the light goes off.

PAPER AND Connection

• Make sure the Bluetooth is on.

Method 1

• Click connect device in APP to connect printer.

Method 2

• After double-clicking the power key Print out the QR code Scan code to connect to the printer.

Replace consumables

• As shown, Push open the cover.

• Place the paper rolI in the direction as shown in figure.

• Close the cover properly.

• service@paperang.com

• www.paperang.com

• Copyright 2022 Xiamen Papering Technology Co., Ltd. All rights reserved.

Safety and Attention

Battery overheating

• Battery management and precautions.
• When charging is complete, we suggest unplugging the charging cable.
• To avoid the risk of fire, please do not charge in high temperature environments (such as steam rooms, near a campfire, etc.).

Attention when using Charger

• Print head management and precautions.
• The print head may be damaged by improper charging.
• We recommend not to use the machine in high humidity or dusty environments.

Burn hazard

• Overheated print head After Printing.
• Do not touch the print head directly.
• To prevent overheating and scalding.

Damage to charging port

• Precautions during charging.
• Please gently insert or pull out a USB cable to prevent damage to the charging port.

FCC COMPLIANCE STATEMENT

This device complies with part 15 of the FCC Rules Operation is subject to the following two conditions:

1. This device may not cause harmful interference.
2. this device must accept any interference received, including interference that may cause undesired operation.
3. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.

• These limits are designed to provide reasonable protection against harmful interference in a residential installation.
• This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
• However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception.

which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
• Changes or modifhcations to this unit not expressly approved by the part responsible for compliance could void the user’s authority to operate the equipment.

FCC Radiation Exposure Statement

• The device has been evaluated to meet general RF exposure requirements.
• The device can be used in portable exposure conditions without restriction.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>