PAPERANG P2 Mobile Mini Photo Printer User Manual

June 12, 2024
PAPERANG

PAPERANG P2 Mobile Mini Photo Printer

Packing list

  1. Paper Printer
  2. Thermal Paper
  3. Charging Cable
  4. Manual

Product Information

PAPERANG-P2-Mobile-Mini-Photo-Printer-product-1

  1. Power key
  2. Reset key
  3. Micro USB
Product name Thermal Printer Charging interface Micro USS
Product model P2Z5 Product spec 6′.J.,85*45mm

1GOg

Input:| 5V=1A
Consumables speciflcations| 57*30mm
---|---
Sa1tery| 1000mAh Li-ion

App Download

Install Paperang App on Your Mobile Device

PAPERANG-P2-Mobile-Mini-Photo-Printer-product-2

Instructions

Turn On/Off

  • Press and hold the power key for 3 seconds
  • Turn on when the light comes on
  • Press and hold the power key again for 3 seconds
  • Turn off when the light goes off

PAPERANG Connection

Make sure the Bluetooth is on

  • Method 1 :
    • Click connect device in APP to connect printer
  • Method 2:
    • After double clicking the power key
    • Print out the QR code
    • Scan code to connect to the printer

Replace consumables

  • As shown, Push open the cover
  • Place the paper roll in the direction as shown in figure
  • Close the cover properly

Safety and Attention

Battery overheating

Battery management and precautions

  • When charging is complete, we suggest unplugging the charging cable.
  • To avoid the risk of fire, please do not charge in high temperature environments (such as steam rooms, near a campfire, etc.).

Attention when using Charger
Print head management and precautions

  • The print head may be damaged by improper charging
  • We recommend not to use the machine in high humidity or dusty environments

Burn hazard
Overheated print head

After Printing

  • Do not touch the print head directly
  • To prevent overheating and scalding
Damage to charging port

Precautions during charging
Please gently insert or pull out USB cable to prevent damage to the charging port

FCC COMPLIANCE STATEMENT:

This device complies with part 15 of the FCC Rules.

Operation is subject to the following two conditions:

  1. This device may not cause harmful interference, and
  2. this device must accept any interference received, including interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/ TV technician for help.
  • Warning: Changes or modifications to this unit not expressly approved by the part responsible for compliance could void the user’s authority to operate the equipment.

FCC Radiation Exposure Statement

  • The device has been evaluated to meet general RF exposure requirement.
  • The device can be used in portable exposure condition without restriction.

Contact Us

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals