1320 RR104-5BT Remote Control Instructions
- June 5, 2024
- 1320
Table of Contents
1320 RR104-5BT Remote Control
INTRODUCTION
Mode
- RR104-5BT
P/N
- RR104-512
You must have one (1) factory key that can start the vehicle to perform this procedure. If you do not have one (1) factory key for the vehicle currently, a trip to a dealership or an automotive locksmith will be required for the programming.
- Enter the vehicle and close the driver’s door.
- Using a working factory key, insert the key into the ignition and turn it to the ON position as far as it will go without starting the vehicle, wait one (1) second, then switch it OFF.
- Remove the key from the ignition.
- Insert the new key into the ignition and turn it to the ON position as far as it will go without starting the vehicle.
- The key is now programmed.
- Test the key to ensure that it starts the vehicle. If the key did not program,restart the programming procedure from STEP 1. To program additional keys, repeat the entire procedure.
Please take attention that changes or modification not expressly approved by
the party responsible for compliance could void the user’s authority to
operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>