MINISO K-346 IPX4 Waterproof Speaker with Suction Cup User Manual
- June 5, 2024
- MINISO
Table of Contents
MINISO K-346 IPX4 Waterproof Speaker with Suction Cup PRODUCT
OVERVIEW
- Power Button
- Play/Pause
- Phone Call
- Nextlraci
- Suction Cup
- Charging Port
- previous Track
- Power Button: Long press to turn on or tum off.
- Play/Pause: Press once to play the music, once more to pause.
- Phone Cell: Short press to answer a call or hang up.
- Next Track: Short press far next track, tong press to tum the volume up
- Previous Track: press once for the previous track, long preSB to tum the volume down.
- Charging Port: Micro USB
- Suction Cup: Fixed on a smooth surface.
PRODUCT PARAMETERS
BT VERSION | V50 | BT NAME | MINISO-K-364 |
---|---|---|---|
BlUETOOTH PROTOCOi.. | A20P, AVRCP HFP. HSP | **** |
INPUT
| ****
DC 5V.500mA
BATTERY| DC 3.7V.
400mM
| FREQUENCY RESPONSE| ****
150Hz-20KHz
SOUND POWER
| ****
JW
| ****
CHARGING PORT
| ****
MaoUSB
TRANSMISSION DISTANCE| About 10m| MUSIC TIME| About 2ti
CHARGING TIME
| ****
About 3h
| |
OPERATION INSTRUCTIONS
F u nc ti on
| ****
I nst r ucti o n
---|---
Turnon/off| Long press the Power Button to lurn on or turn off.
Play/Pause the Music| ‘Nhen themusicIsplaying, shortpressthe Play/Pause
button.
Next Track| Short press Next Tr.tek button.
PreVK>Us Tr ack| Short press PreviOus Track bu ttoo.
Volumeup| Longpress Next Track button.
Volume dO’Ml| long press Previous Track button.
Answer a Call/Hang up| Short pressPhone Ca ll button to answer a callor hang
up
CAUTIONS
- Store and use the product at room temperature.
- Do not throw the product to avoid damage caused by dropping.
- Do not disassemble, repair or modify the product yourself.
- The product has e built-in lithium battery, wliich is not replaceable. Do not discard it or 10$5 it in fire to avoid danger.
- To prevent its performance from being affected, keep it away from strong magnetic objects.
- When not in use for a long time, charge the speaker every 3 months to extend the battery lifespan.
TROUBLESHOOTING
-
The wireless speaker is unaD1e to pair with the cell phone. Solution: Confirm if the wireless speaker is in pairing m<Xla and if the Bluetooth on your phone is toggled on. Alien delete the product in the list, pair It with your phone again according to the User Manual.
-
The wireless speaker is unable to be turned on.
solution: Confirm the battery level. Charge the speaker if it is needed. -
Can the battery of the wireless spHkar be replaced? Solution: No, this is a lithium polymer battery, which is irreplaceable.
-
Can I use the wireless speaker at a high volume for a long time? column: To ex. tend the lifespan of the wireless speaker, it is not recommended to play it at a high volume for a long time
-
The link between the wireless speaker and the mobile has been disconnected within 1 o meter.
Solution: Bluetooth Is wireless so It Is very sensitive lo objects between the speaker and the connected device. Check if there are any metal or other objects that may affect the connection within the effective distance.
a.Cannot hear audio playing when the speaker is connected to the computer or phone.
Solution: Check whether the computer’s audio output is already connected to the wireless device and whether the Bluetooth in the computer supports A2DP protocol. Make sure the volume is up on your plane or computer. -
Can I operate lhe Apps of my phone through the speaker after pairing the wireless speaker Witt, the phone?
Answer: Some apps may not support being operated through the speaker due to their settings
ACCESSORIES
- The product x 1
- user manual ” 1
- CHARGING CABLE 1
FCC Warning
This device complies with Part 15 of the FCC Rules, Operation is subject to the following two conditions:
- This device may not cause harmful interference, the end
- Thls device must accept any Interference rece1Ved, enduring interference that may cause undesired operation.
Caution: Changes or modifications not expressly approved by the party
responsible for compliance coul<J void the user’s authority to operate the
equipment.
NOTE: This equipment has been tested and found lo comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses, and can radiate radk)
frequency energy and, if not installed an’1 use’1 in accordance with th&
instructions, may cause harmful interference to radio communications. However,
thete is no guarantee that interference will not occur In a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
e minimum distance Of 20¢m between the redietor and your bOdy. This
1ransmitter must not be co-..located or operating in conjunction with any
other antenna or transmitter.
IC Warning
This device contains a license-exempt transmitter(receiver(s} that comply with
Innovation, Science and economics. Development Canada’s
license-exempt RSS(s). Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
The device meets the exemption from the routine evaluation limits in section
2.5 of RSS-102 and compliance with RSS-102 RF e.xposure, users can obtain
Canadian information on RF exposure end compliance. This equipment should be
installed and operator with a minimum distance of 20 centimeters between the
radiator and your body,
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>