PRIME Wire and Cable TNRC21 2-Outlet Indoor Wireless Remote Control User Manual
- June 5, 2024
- PRIME Wire and Cable
Table of Contents
PRIME Wire and Cable TNRC21 2-Outlet Indoor Wireless Remote Control
Introduction
The user manual
This product is a Remote remote control transmitter, the hardware includes a
Remote chip (HF1632), a Red LED, two button switch RCTM21-1 can be used with
Beacon socket
- Connect the beacon socket to 125V power supply
- After the beacon socket is powered ON, press ON/OFF back and forth within 10 seconds
- 3. If the beacon socket can be controlled, the pairing is successful
RCTM21-1 key function description
- ON: Open the socket
- OFF: Close the socket
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority
to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
RF warning statement:
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>