AEG DCK5970HM 90cm Ceiling Extractor Hood User Manual

: June 5, 2024
: AEG

Table of Contents

AEG DCK5970HM 90cm Ceiling Extractor Hood
CUSTOMER CARE AND SERVICE
SAFETY INFORMATION AND INSTALLATION
PRODUCT DESCRIPTION
DAILY USE
CARE AND CLEANING
ENVIRONMENTAL CONCERNS
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

AEG DCK5970HM 90cm Ceiling Extractor Hood

FOR PERFECT RESULTS

Thank you for choosing this AEG product. We have created it to give you impeccable performance for many years, with innovative technologies that help make life simpler – features you might not find on ordinary appliances. Please spend a few minutes reading to get the very best from it.
Visit our website to:

Get usage advice, brochures, trouble shooter, service and repair information: www.aeg.com/support
Register your product for better service: www.registeraeg.com
Buy Accessories, Consumables and Original spare parts for your appliance: www.aeg.com/shop

CUSTOMER CARE AND SERVICE

Always use original spare parts.
When contacting our Authorised Service Centre, ensure that you have the following data available: Model, PNC, Serial Number.
The information can be found on the rating plate.

Warning / Caution-Safety information
General information and tips
Environmental information
Subject to change without notice.

SAFETY INFORMATION AND INSTALLATION

WARNING!
Refer to the separate Installation Instructions booklet for Safety Information and Installation. Read carefully the Safety chapters before any use or maintenance of the appliance.

PRODUCT DESCRIPTION

Control panel overview

| Function| Description
---|---|---
1| Lamp| Turns the lights on and off.
2| First speed / Off| The motor switches to first speed level. Second press turns off the appliance.
3| Second speed| The motor switches to second speed level.
4| Third speed| The motor switches to third speed level.
5| Maximum speed| The motor switches to maximum speed level. After 5 minutes appliance switches to third speed.
6| Filter notification| Reminds to change or clean the charcoal filter and clean the grease filter.
7| Hob²Hood| Indicator of the function to control hood from hob. For some models the symbol present on the control panel.

DAILY USE

Using the hood
Check the recommended speed according to the table below.

While heating up food, cooking with covered pots.

    While cooking with covered pots on multiple cooking zones or burners, gentle frying.
    While boiling and frying big quantities of food without a lid, cooking on multi‐ ple cooking zones or burners.
    While boiling and frying big quantities of food without a lid, big humidity.

It is recommended to leave the hood operating for approximately 15 minutes after cooking.
To operate the hood:
1. Press the first speed button to switch on the appliance.
2. If needed, change the speed by pressing the desired button.
  The hoods light works independently to other hood functions. To illuminate the cooking surface press the light button

To turn off the appliance press the first speed button again.
Hob²Hood function
It is an automatic function which connects the hob with a hood. Both the hob and the hood have an infrared signal communicator. Speed of the fan is defined automatically on basis of mode setting and temperature of the hottest cookware on the hob. You can also operate the fan using the hob manually. The function can be activated from panel of the hob.

For more information how to use the function refer to the hob user manual.

Filter notification
Filter alarm reminds to change or clean the charcoal filter and clean the grease filter. The filter indicator is turned on for 30 seconds if the grease filter must be cleaned. The filter indicator flashes for 30 seconds if the charcoal filter must be replaced or cleaned.

Refer to cleaning the grease filter in care and cleaning chapter.
Refer to cleaning the charcoal filter or replacing the charcoal filter in care and cleaning chapter.

To reset the function press the button for 3 seconds.
To activate or deactivate function:

To activate function press the button for 3 seconds.
If the function is activated, the indicator flashes two times.
To deactivate function press the button for 3 seconds.
If the function is deactivated, the indicator flashes ones.

Remote-control

The appliance is supplied with a remote-control.
The connection is originally enabled.

To connect or disconnect remote control:

Switch off the appliance.
Press the for 3 seconds.
The indicator on control panel flashes twice if function is enabled and once if disabled.

CARE AND CLEANING

Notes on cleaning

Cleaning Agents

| Do not use abrasive detergents and brushes.

Clean the surface of the appliance with a soft cloth with warm water and a mild detergent.

---|---
After cooking some parts of appliance can get hot. To avoid stains ap‐ pliance must be cooled down and dried with clean cloth or paper tow‐ els.
Clean stains with a mild detergent.
The time of saturation of the charcoal filter varies depending on the type of cooking and the regularity of cleaning the grease filter. Charcoal filter is washable, clean or regenerate the filter after approximately ev‐ ery two months. Refer to leaflet included in the accessory.

Charcoal filter

Cleaning the grease filter
Filters are mounted with the use of clips and pins on the opposite side.
To clean the filter:

Pull the cover to open it.
Press the handle of the mounting clip on the filter panel underneath the hood (1).
Slightly tilt the front of the filter downwards (2), then pull.
Repeat the first two steps for all filters.
Clean the filters using a sponge with non abrasive detergents or in a dishwasher.
The dishwasher must be set to a low temperature and a short cycle. The grease filter may discolour, it has no influence on the performance of the appliance.
To mount the filters back follow the first two steps in reverse order. Repeat the steps for all filters if applicable.

Cleaning the charcoal filter
To remove the filter:

Remove the grease filters from the appliance.
Refer to “Cleaning the grease filter” in this chapter.
Remove the clips holding the filter bed (1), then the filter bed (2).
Wash the filter bed in hot water without using detergent or use a dishwasher.
Set the dishwasher without using rinse aids or any other detergents. The dishwasher cannot be filled with dishes.
Leave the filter bed to dry or use an oven.
WARNING!
Risk of burns! Refer to safety chapter in oven user manual.
Set the oven for 10 minutes in the maximum temperature of 60°C.
To install the filter, perform the steps in reverse order. The filter has to be fully dried before installing it back into appliance.
Replace the filter bed every 2 years or when the cloth is damaged.

Replacing the lamp
This appliance is supplied with a LED lamp and separate control gear (LED driver). These parts can be replaced by a technician only. In case of any malfunction refer to “Service” in the “Safety Instructions” chapter.

ENVIRONMENTAL CONCERNS

Recycle materials with the symbol . Put the packaging in relevant containers to recycle it. Help protect the environment and human health by recycling waste of electrical and electronic appliances. Do not dispose of appliances marked with the symbol with the household waste. Return the product to your local recycling facility or contact your municipal office.