amzchef NY-8628MC Multi Function Blender Instruction Manual

amzchef NY-8628MC Multi Function Blender

IMPORTANT SAFETY INFORMATION

Please read these notes carefully before using your blender appliance. Misuse of the product may cause damage to property and people,please use it only according to the procedures explained in this manual.

• Check that the voltage of the main circuit corresponds with the rating of the appliance before operating
•  If the supply cord or appliance is damaged, stop using the appliance immediately and seek advice from the manufacturer, its service agent or a similarly qualified person.
• Do not let the cord hang over the edge of a table or counter or let it come into contact with any hot surfaces.
•  Do not carry the appliance by the power cord.
• Do not use any extension cord with this appliance.
• Do not pull the plug out by the cord as this may damage the plug and/or the cable.
•  Switch off at the wall socket then remove the plug from the socket when not in use or before cleaning.
•  Switch off and unplug before fitting or removing tools/attachments, after use and before cleaning.
• Close supervision is necessary when any appliance is used by or near children.
•  Children should not play with the appliance.
• This appliance can be used by people with reduced physical, sensory or mental capacity or lack of experience and knowledge only under supervision or if they have received instructions regarding the use of the device safely and if they understand the dangers involved.
• The product should not be used by children; the product and its cable should be kept away from them.
•  Take care when any appliance is used near pets.
•  Do not use this product for anything other than its intended use.
•  This appliance is for household use only.
•  Please ensure that the appliance is used on a stable, level, and heat resistant surface.
•  Do not immerse cords, plugs or any part of the appliance in water or any other liquid.
•  Do not use the appliance outdoors.
•  WARNING: Pay attention to sharp blade when filling/emptying the pitcher and during cleaning operations. Handle with Care.
• Never let the power unit, cord or plug get wet.
•  To reduce the risk of injury, never place cutter-assembly blades on base without blender jug properly attached.
•  Never exceed the maximum capacity.
•  Do not attempt to bypass the interlock system that powers the unit on.
•  Always operate on a flat surface.
•  Unplug the blender when not in use, before taking off or putting on parts and before cleaning.
• Warning: Do not use if the blending cup is cracked or broken.
•  Do not operate the Blender when the blending cup is empty.
• If the blade assembly blades are loose, discontinue use immediately and replace the blade assembly. Do not attempt to repair or tighten blade assembly.
• Inspect container and cutter assembly daily. Do not use broken, chipped or cracked container. Check blade assembly for wear,nicks, or broken blades. Do not use broken or cracked blades.
•  To prevent damage to blender, container, or blade assembly.
• DO NOT move or shake blender while in operation
•  Be careful if you pour hot liquid inside the jug as this can cause a sudden leak of steam
• When removing the jug from the blender base you must wait until the blades have stopped spinning. Removing the jug whilst the blades are spinning can cause damage to the blender.
• In the unlikely event the appliance develops a fault, stop using it immediately and seek advice from the service department in order to avoid any risk.

COMPONENTS

1. Removable filler cap
2. Lid
3. 2L Jug
4. Blade assembly
5.  Rubber base
6. Pulse Switch
7.  Speed selector dial
8. Non slip feet
9. ON/OFF switch

TECHNICAL DATAS

Product Model| Voltage| Power| Capacity| Max. Speed
---|---|---|---|---
NY-8628MC| 220V-240V

50/60Hz

| 1500W| 2.0L| 26000RPM

low speed, pressing the PULSE button will increase the speed of the Bar Blender.
Tips
When you are using many ingredients, always ensure the liquid ingredients go into the jug first, followed by the solids. Make sure all ingredients are cut into even sized pieces for good consistency. When blending liquids, do not exceed the 1 litre mark.

CLEANING

Please refer to all instructions included in this book. Clean the appliance after every use.

• The jug and lid are dishwasher safe. Do not wash the blade assembly in the dishwasher as this can damage the silicone gasket seal. Do not immerse your Bar Blender in water or any liquids.
• Remove plug from the mains socket and allow the appliance to cool down before cleaning.
• Do not immerse the base unit of the appliance in water and ensure no water enters the appliance.

1. Clean the base unit by wiping it with a damp cloth. A little detergent can be added needed.

HOW TO OPERATE

1. Place the blender on a dry, level surface.
2. Ensure the On/Off switch and the speed selector dial are in the off (Min) position.
3. Fill the jug with your ingredients and attach the lid before fitting the jug onto the base of the blender.
4. Push the jug into place. If it is not fitted correctly, the blender will not work.
5.  Plug the blender into an electrical outlet and switch on.
6. Turn the On/Off switch to the On position.
7. Set the speed selector dial to your required speed.
8. You can use the manual speed selector dial to control the speed during use.
9. To stop blending, turn the On/Off Switch to the Off position.

Speed adjust
The blender has an analogue speed dial, working from left to right.Due to the slow start motor, the blender will begin slowly and speed up to the selected speed.
PULSE function
The PULSE function is used for short and powerful blend at optimal speed. You can control how long the machine runs it. For example, it can be used towards the end of a mixing, to make your smoothie perfect. The button must be held down for use, and when released, the blender goes back to the initial speed; if you are blending at a solvents or abrasive cleaning agents to clean the appliance; they may damage the outside surfaces of the appliance. Clean blade assembly in warm soapy water. Do not use any scouring pads, steel wool, any strong solvents or abrasive cleaning agents when cleaning accessories. To clean the blades connect the blade assembly and fill the jug half way with warm soapy water, and function for 30 seconds. Empty the waste water and rinse with fresh hot water. Repeat if necessary

HOW TO STORE

1. Unplug the appliance.
2. Make sure all parts are clean & dry and placed in a clean and dry place.
3. Store the blender upright with the lid secured on top.

Any other servicing should be performed by an authorized service representative.

TROUBLESHOOTING

Warning: To reduce the risk of shock and unintended operation, turn of power and unplug unit before troubleshooting.

Blender fails to start or stops while it is running and cannot be restarted.

| 1.   Check to see if unit is securely plugged into an electrical outlet.

2.   Make    sure     the     container     is securely placed on the motor base. 3.The motor stops during operation due to overheating. Allow the blender to cool down for 20 minutes.

The blender don’t switch on.| Make sure the blade assembly is properly assembled to the jar and that it is not misaligned.

Blender doesn’t turn off.

| Unplug the power electrical outlet and service for support.| cord call| from the customer

Ingredients      are      not mixing properly.

| 1.   Ensure you have added enough liquid to the ingredients. Your mixture should be fluid at all times.

2.  You may have exceeded the max fill line on the jug. Do not fill past the

highest graduation marking.

Food chopped.| is| unevenly| Either you are chopping too much food at once, or not pulsing properly. Reduce the amount of food in the jar.
Hot smell emitting from unit.| The blender might have overheated, allow to cool before reusing.

ADDITONAL FAQS

1. How small do I need to chop my ingredients?
Make sure all ingredients are cut into 1 inch cubes for optimum results.
2. Do I need to peel my ingredients?
It is recommended to peel any fruit with a fibrous, thick skin, such as bananas and oranges. Depending on personal taste you can leave skins.
3. You cannot achieve crushed ice from ice cubes.
For best results, use ice straight from the freezer. Attempt a shorter operating time. This marking indicates that this product should not be disposed with other household wastes throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To return your used device, please use the return and collection systems or contact the retailer where the  product was purchased. They can take this product for environmental safe recycling.

WARRANTY

Dear Customer,
Thank you for choosing AMZCHEF product. We sincerely hope that you are satisfied with it. The manufacturer’s warranty covers the product for a period of 24 months from the date of purchase against manufacturing faults. If you encounter any problems during using, please contact us via info@iamzchef.com, we will service you within 24 hours. When sending email, we suggest to provide a warranty card, a photo or a video if there’s broken spare part or not working machine so that we can be much more clearer about your problem and offer you the best solution.

The device meets the requirements of Regulation 2014/35/EU as well as the applicable standards EN60335-1:2012+A11:2014+A13:2017, EN60335-2-14:2006/A12:2016, EN 62233: 2008 Manufacturer: Zhongshan City Nyyin Electrical Co.,Ltd. Add.: No.46 Xingye North Road,Nantou Town, Zhongshan City, Guangdong Province, China Name: APEX CE SPECIALISTS LIMITED Add.:UNIT 3D NORTH POINT HOUSE,NORTH POINT BUSINESS PARK,NEW MALLOW ROAD,CORK,T23 AT2P,IRELAND logistic01@iamzchef.com

Kindly send back the warranty card to us after filling in the information. Thanks for your effort!

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>