ROBOQI W07 Magnetic 3-in-1 Wireless Charger User Manual
- June 5, 2024
- ROBOQI
Table of Contents
ROBOQI W07 Magnetic 3-in-1 Wireless Charger
Product introduction
This product is an intelligent wireless charger.
Design is concise and simple, and compatible with Ql standard mobile phones
and devices.
Charging device wireless plug and unplug, convenient and swift.
Provide you with unconstrained and secure wireless charging experience.
Product parameters
- Wireless charger
- Data line
- User manual
Product Specifications
- Input parameters: 9V-2.22A 12V-2A
- Output parameters: Mobile phone: 15W/10W/7.5W
- The headset: 5 W
- Watch: 3 w
- Interface Type: Type-C
- product size: folding: 88x78x27mm
A: 248 x88x9mm
Directions for use
- Connect the USB data cable to the external power adapter and connect the power supply:
- Connect the TYPE-C interface of THE USB charging cable with the product;
- Place your phone, watch and earphone pod on a wireless charger.
Matters needing attention
- Keep the charger and receiver away from water and other liquids;
- If you need to clean the charger, please disconnect the power supply first.
- The ambient temperature is kept at 0-45C.
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
Warning: changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment
Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator and your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>