sleepytroll 2399 Baby Rocker Instruction Manual
- June 5, 2024
- sleepytroll
Table of Contents
baby rocker
Congratulations on purchasing your new Sleepytroll Baby Rocker! For the latest information visit www.sleepytroll.com
Introduction
The Sleepytroll is designed to attach to prams & strollers, and to gently rock your baby to sleep. It features two modes, Sensor mode, and Basic mode. In Basic mode, it will rock for 40 minutes before automatically turning off. In Sensor mode, Sleepytroll will monitor sound and movement and start rocking when your baby becomes restless. This product is intended to aid your child in sleeping and is not intended to replace a carer or be used over an extended length of time.
Safety information
Please read these user instructions before using the product, and keep them
for future reference. Symbols used:
= Warning – Risk of personal injury
= Notice – Risk of damage to the device
Warning – This product is not a toy and should be used by adults only.
Position the product out of reach of the child. Charge out of reach of
children.
Warning – Adult supervision is required, do not leave your child
unattended.
Warning: Sleepytroll can produce a powerful rocking motion. This
allows the product to rock large/heavy prams. Always use the lowest setting
that works with your pram and child´s weight combination and simulates your
normal hand rocking. It is your responsibility to make sure that your child is
comfortable with the rocking effect setting you choose, as too powerful
rocking might discomfort or harm your child.
Warning – Never expose the charger to water/moisture. Risk of electric
shock. Never charge the product when wet.
Warning – Use only the supplied charger to charge the product. Risk of
electric shock/ire!
Warning – Always lock the brakes on the pram/stroller before using the
product. Using the product with brakes unlocked may cause the pram/stroller to
move.
Warning – The pram/stroller should be positioned on a level/flat surface.
Positioning on a slope may allow the pram/stroller to move undesirably.
Notice
- The Sleepytroll is tested to IPX2 (light rain). Do not use the product in prolonged or heavy rain.
- Remove the product from the pram/stroller after use and store it in a safe, dry place, out of direct sunlight.
- Do not open the product, it contains no user-serviceable parts, and doing so will invalidate your warranty. If the product is not working correctly contact your place of purchase.
Charging
When the Battery Indicator light shows red, the batteries are running low and
it is time to charge the product. Remove the Sleepytroll from the stroller.
Open the Charger Door and insert the charger plug. The light on the
Sleepytroll will show red while charging, and green once the batteries are
fully charged (usually after 2-2.5 hours). Press the Charger Door closed when
finished. The product will not function while charging. Charge the product
fully before first use.
Warning – Do not use the charger outdoors, in wet/damp conditions, or near heated surfaces. Risk of electric shock/ire!
Storage and battery care
When not in use, remove the charger from the wall and store the product in a dry place out of direct sunlight and out of reach of children. When storing the product for long periods, be sure to charge at least twice a year to prevent deterioration in performance due to self-discharging, and choose a storage area where the temperature is between +10ºC and +30ºC. To restore the battery to original performance repeat several cycles of charging and discharging (run product at the maximum effect on an empty pram until the batteries are lat)
Cleaning and Maintenance
Clean the product with a cloth dampened with water only.
Do not use soap or chemicals on the cloth.
**** Never submerge the product or charger in water or rinse under running
water. Ensure both product and charger are dry before using.
Positioning the product
Orient the product with the buckle towards your child (the sound sensor is on this side) and position it out of your child´s reach.
The product should only be attached and used in a vertical position. Usage while not hanging vertically will reduce the motor life.
1. Attaching the product
-
Place your hand under the product to prevent dropping.
-
Orient the buckle towards your child (the sound sensor is on this side) and position it out of your child´s reach.
-
Pass the ladder strap around the handle and feed into the ratchet buckle until you hear a click.
2. Attaching the product
-
Keep the product vertical as you tighten the ratchet. Tighten by rotating the ratchet lever (marked in grey) upwards, repeating until tight. The product should be firmly attached (not loose), but do not tighten so much that it deforms the product or stroller.
Removing the product
- Hold the product underneath to prevent dropping.
- Open the ratchet release (marked in grey) and move the product downwards until the ladder strap is loose.
A Universal ladder strap
Attach product to pram handlebar. The product should always be oriented
vertically.
B Battery / Charging / Status indicator
- Lights up when the product is on.
- Battery level: Green = Full, Yellow = Medium, Red = Low
C On / Increase rocking
- Press and hold for 2 seconds to turn the product on.
- The product will rock for 40 minutes and then stop.
- Use short presses to increase the rocking effect.
D Of / Decrease rocking
- Press and hold for 2 seconds to turn the product off.
- Use short presses to decrease the rocking effect.
E Sleep watch Sensor Mode
- Short press to activate Sensor Mode (symbol is lit).
- Rocking starts automatically if sound or movement is detected. (The sensitivity can be adjusted).
- Short press again to deactivate Sensor Mode.
- Alternatively, hold and buttons together for 2 seconds to start directly in Sensor mode.
F Charger port
- Open lap and plug-in charger plug to charge product.
- Only use the supplied charger and only charge indoors.
- For the safety of your child, the product can not be used while charging.
Sleep watch Sensor Mode
In Sleepwatch Sensor Mode the Sleepytroll will remain still until it detects
movement or noise from your baby. It will then rock the pram for 3 minutes,
and will then wait until
it detects movement/sound again.
Pressing the button activates and deactivates Sensor mode. Alternatively, hold
and buttons together for 2 seconds to start the product directly in Sensor
mode.
We recommend using the product in Sleepwatch Sensor Mode so as to rock only
when your child is restless and to maximize battery runtime. Note:
Sleepytroll will turn off automatically if sensors detect constant
sound/movement.
Sensor Adjustments
If the sound or movement sensors are either too sensitive or not sensitive
enough, you can adjust the sensitivity.
Sound Sensor adjustment:
- Press the button to activate Sensor Mode
- Hold the button for 5 seconds until the battery indicator starts blinking to indicate adjustment mode and the indicator color shows the sensitivity level.
- Press to increase Sensitivity or to decrease.
Sensitivity colors: Lowest = Red, Low = Yellow,
Medium = Green, High = Light Blue, Highest = Blue
4. Hold the button for 5 seconds to leave Adjustment mode.
Movement Sensor adjustment:
- Press the button to activate Sensor Mode
- Hold the button for 10 seconds (keep holding even though the battery indicator starts blinking after 5 seconds). The battery indicator blinking indicates adjustment mode, and the color shows a sensitivity setting.
- Press to increase Sensitivity or to decrease. Sensitivity colors: Lowest = Red, Low = Yellow, Medium = Green, High = Light Blue, Highest = Blue
- Hold the button for 5 seconds to leave Adjustment mode.
Troubleshooting
Does the product stop after 40 minutes? The product is programmed to stop
after 40 minutes. You may use the product in Sleepwatch Sensor mode to monitor
your child’s sleep and rock as necessary over a longer period.
Product will not start? Check the battery is fully charged and the
charger is disconnected. Position Sleepytroll to hang vertically.
The rocking effect is too strong or too weak? Check that the product is
firmly attached to the stroller handle, and adjust the rocking speed.
The product is too sensitive / too little sensitive to sounds in Sensor
Mode? Adjust as described under Sensor Mode.
The product is too sensitive / too little sensitive to movement in Sensor
Mode? Adjust as described under Sensor Mode.
All buttons and lights lash, and the product will not run? This indicates
that the motor has difficulty rocking the product and is a safety cutout
feature. Check that the product is hanging vertically on the stroller, that
the batteries are charged, and try again. If the problem persists contact the
store you purchased Sleeptroll from.
Frequently Asked Questions
-
What age child can the Sleepytroll be used with?
The product can be used with children aged 0-3. -
Does the product remember my previous setting?
Yes, the Sleepytroll will start in the same mode and rocking effect the next time you turn it on. -
What temperature range can I use Sleepytroll in?
The Sleepytroll can be used in temperatures from -10 to +35 degrees. Cold temperatures will affect the battery during use so lower battery capacity should be expected.
Warning, cold conditions can put your child at risk!
Check health/safety recommendations in your country and protect your child
appropriately.
-
How do I choose the best rocking setting for my pram?
All prams are different, adjust the rocking effect setting so that it gives the desired movement to suit your child. -
Can I attach the Sleepytroll anywhere on the pram?
Attach the Sleepytroll out of reach of your child. For best results attach it high up and on the main handlebar, hanging vertically. -
Can I use the Sleepytroll in the rain?
The Sleepytroll is tested to IPX2 and can be used in light rain.
Do not expose the Sleepytroll to prolonged or heavy rain. -
Why is it called Sleepytroll?
The name Sleepytroll is inspired by the Norwegian stories of trolls known for sleeping during the daytime.
Recycling
- This symbol means that this product shall not be disposed of with normal household waste. (2012/19/EU). The product contains a built-in rechargeable battery which shall not be disposed of with normal household waste (2006/66/EC). Please take your product to an official collection point to have a professional remove the rechargeable battery.
- Follow your country´s rules for the separate collection of electrical and electronic products and rechargeable batteries. Correct disposal helps prevent negative consequences for the environment and human health.
- Packaging: The paper and cardboard packaging used can be disposed of as recyclable paper. The plastic wrapping may be recycled or disposed of, depending on the requirements in your country.
Removing the rechargeable battery (professional only)
Warning: Only remove the rechargeable battery when the product is to be
discarded. Make sure the battery is completely empty when you remove it. To
remove the battery you will need a Philips (cross head) screwdriver, an 2.5mm
Allen/hex key, and a knife or pair of snips. Observe basic safety precautions
when you follow the procedure below and be sure to protect your eyes, hands,
fingers, and the surface on which you work.
- To deplete the rechargeable battery of any charge, start the product and run it in Basic mode at maximum speed. Repeat this step until you can no longer turn on the product.
- Open the ladder strap fully, and undo the 2 hex screws on top of the product. Now undo all 6 Philips screws at the back of the product.
- Carefully pull the Front and Rear halves away from each other to expose the mechanism inside.
- Carefully unplug the wires to both battery packs and cut the cable ties that hold them in place and remove the battery packs.
- The rechargeable battery pack can now be recycled and the rest of the product discarded appropriately.
Warranty and support
If you need information or support, please visit:
www.sleepytroll.com
The terms of the international warranty do not cover the following:
- Damage caused by misuse, abuse, neglect, or unauthorized repair.
- Normal wear and tear, including chips, scratches, abrasions, discoloration, or fading.
Note: The motor inside the Sleepytroll may become louder after a period of use, this is normal for a brushed motor. Using the product while it is not hanging vertically will shorten the motor life of your Sleepytroll.
Regulatory information
Electromagnetic fields (EMF). The Sleepytroll complies with CE and FCC
regulations regarding exposure to electromagnetic fields.
Sleepytroll Product
Model: SLT001
Operating Temperature: -10 to 35 degrees
Battery type: Rechargeable NiMH
Packaging dimensions W x D x H:
Packed: 114 x 108 x 190mm, Unpacked: 74 x 90 x 167mm
Weight, Packed: 0.88kg Product unpacked: 0.65 kg
ROHS (Reduction of Hazardous Substances) compliant
Charger
Model: ICP0SC-050-1000D
Input: 100-240V, 0.3A, 50/60Hz
Output: DC 5V, 1000mA
Designed in Norway by Abry & Kavanagh Design AS.
Made in China
Sleepytroll is a registered trademark of Babyliss AS.
Patented and Design registered.
Babyliss AS
Ralph Tambsvei 10B
NO-1384 Asker, Norway
July 2020 Bablis AS: v100020
CARDBOARD
widely recycled
PLASTIC
check local recycling