KC HiLiTES 91313 50 Inch Pro6 Gravity LED 8-Light Light Bar System Instructions
- June 3, 2024
- KC HiLiTES
Table of Contents
KC HiLiTES 91313 50 Inch Pro6 Gravity LED 8-Light Light Bar System
Thanks for choosing KC HiLiTES products; your satisfaction is very important to us. if you have any questions regarding this product or any other KC HiLiTES products, please contact us at 888-689-5955 or visit kchilites.com.
PARTS INCLUDED
- 1 – 50” LED light bar with wiring
- 1 – Above windshield light mounting bracket set 10 – M8 x 1.25 x 30 mm Black Zinc Bolts
- 10 – M8 Black Zinc Washers
- 2 – Protective Rubber Gaskets
MOUNTING THE BRACKETS
- Remove the upper five of the six Torx head bolts from each of the windshield frame brackets. These are located in the lower corner of the driver and passenger side of the windshield.
- Align the rubber protective gasket with the holes on the vehicle and secure temporarily with small pieces of scotch tape or similar.
- Place the bracket on the gasket and start each of the five M8 bolts and washers. Tighten all by hand. Remove the tape used to secure and then tighten all bolts.
- Repeat procedure for opposite side of vehicle.
- Install your 50” C50 LED bar to the brackets and wire it according to the instructions included with the LED bar.
YOU’RE DONE
KC HiLiTES, Inc., Williams, AZ USA 888-689-5955 www.kchilites.com KC3265AW v20170803
References
- KC Lights | The Original Off Road Lights - Adventure Further
- KC Lights | The Original Off Road Lights - Adventure Further
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>