QUANTUM Q168P SUBWOOFER SYSTEM Owner’s Manual
- June 5, 2024
- quantum
Table of Contents
QUANTUM Q168P SUBWOOFER SYSTEM
SAFETY INSTRUCTIONS
- Ensure that your subwoofer enclosure will not get loose during the drive and hurt someone in the passenger cabin.
- It is recommended, that you mount the subwoofer enclosure with suitable belts or any other mounting solutions in the trunk area.
- Please ensure not to damage any serial components of your vehicle (air bags, wires, gas tank etc.) during the installation of your sound system by drilling or any other operations.
- Please ensure by any means the correct polarity of all connections.
- Faulty installed and connected devices may get damage the vehicle and the device permanently.
- Please check in any case the operation guide or wiring manual of your amplifier which you’d like to use for the Soundsystem.
- Never connect the speaker terminals with the 12 Volt power supply, otherwise, the speakers may get damaged.
POWER RATING
ESX subwoofer enclosures are designed for high bass levels. Anyhow it is possible, that unsatisfying sound characteristics could be caused by too low or too high amplifier power. In certain circumstances, this even can cause damage to the loudspeakers. It is recommended to choose rather a more powerful amplifier (ca. 15-20% more Watts RMS than the max. RMS power rating of the woofer) and to use the amplifier, not at the maximum output level (distortion factor, good sound characteristics). A weaker amplifier at the maximum level causes worse sound characteristics due to the higher distortion factor. Never crank up the output volume of your amplifier to the maximum level or run the amplifier into theclipping range. If the sound is distorted and not clean, turn back the level until the distortions disappearESX subwoofer enclosures have no integrated limiter or clipper, which is limiting the level upwardsOveramplified bass peaks lead inevitably to a burnout of the voice coil of the woofer. A burnout of thevoice coil, caused by clipping/oversampling is not covered by the usual warranty.
SPECIFICATIONS
- Q168P
- Subwoofer 15 x 20 cm (6“ x 8“)
- Power Rating 100 Watts RMS
- 200 Watts max.
- Impedance 2 Ohms
- Frequency Range 30 – 150 Hz
- Dimensions 195 x 74 x 260 mm
CONVENTIONAL CONNECTION
Connection of one Q168P
Connection of two Q168P
CONNECTION WITH QUICK CONNECT
Connection of a Q168P to a compatible amplifier with Quick Connect such as
XE6440 DSP
Connection of two Q168P to a compatible amplifier with Quick Connect such
as XE6440 DSP
Documents / Resources
|
QUANTUM Q168P SUBWOOFER
SYSTEM
[pdf] Owner's Manual
Q168P SUBWOOFER SYSTEM, SUBWOOFER SYSTEM, SYSTEM
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>