Shenzhen Youcaijia Technology BM9811 Bluetooth Mouse User Guide
- June 5, 2024
- Shenzhen Youcaijia Technology
Table of Contents
Shenzhen Youcaijia Technology BM9811 Bluetooth Mouse
Bluetooth connection
Two methods are described as follows:
Quick connect:
The BM9811 host supports the quick connect function.
When connecting for the first time, first check that the bluetooth on the host
side is turned on, pull the power switch on the back of the mouse from OFF to
ON position, then the blue LED will light up, then press the Connect button
next to it, at this time, the BM9811 host screen will appear In the following
interface, click the [Connect] button to complete the Bluetooth connection
.
Normal connection
The BM9811 host supports the quick connect function.
When connecting for the first time, first check whether the Bluetooth on the
host side is turned on, pull the power switch on the back of the mouse from
the OFF position to the ON position, the blue LED will light up at this time,
and then press the Connect button to open the Bluetooth connection interface
on the BM9811 host. Click to select the device “Samsung BT Mouse” to connect,
as shown below:
When the screen as shown in the figure below appears, it indicates that the connection is successful. Click the [done] button to start using.
Low power and charging instructions
The white LED in the middle of the front of the mouse starts to flash. At this time, you need to prepare to replace 2 AAA dry batteries.
Back connection Description
If the BM9811 mouse has been successfully connected to the host, the Bluetooth connection will be performed automatically after the mouse is powered on next time. If the connection is unsuccessful, please check whether the Bluetooth switch of the host is turned on, or press the Connect button for 2 seconds, release it, the white LED flashes, enter the pairing mode, and then reconnect the Bluetooth according to one of the above two methods.
Product parameters
Bluetoothversion
|
BT5.2
|
Working hours
|
40 天
---|---|---|---
Operating Voltage
|
1.3~3.2
|
Working current
|
<6mA
Powered by
|
AAA*2
|
Working distance
|
10m
Working temperature
|
5℃~45℃
|
Working humidity
|
10%~85%
FCC Rules
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>