MAXCONTROL BL2160PNH800UP Remote Control User Manual
- June 5, 2024
- Maxcontrol
Table of Contents
MAX CONTROL BL2160PNH800UP Remote Control
Pairing New Remote method
- Press [Power] Key to turn on the [TV]
- Press and Hold [VOL-] key and[ ] key together for 3-5 seconds, the indicator light flashes and enters the pairing state. After the pairing is successful, the indicator light will go out.
Connected new remote with a Paired Remote
- Press the [Home] key, then select [Setting- Remotes & accessories]
- Select [Add accessory], then Press [OK] key to confirm to pair.
- Press and Hold [VOL-] key and [ ]key together for 3-5 seconds, the indicator light flashes and enters the pairing state. After the pairing is successful, theindicator light will go out.
FCC Statement
This equipment has been tested and found to comply with the limits tor a Class B digital device, pursuant to part 15 of the FCC Rules. These Limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the intentions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a part installation. lf this equipment does cause harmul interference to radio or television reception, Which can be determined by turning equipment off and on, the user 1S is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receivng aed.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by the manufacturer could void your authority to operate this equipment This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interterence, and (2) this device must accept any interference received, including interference that may cause undesired operation.
RF Exposure Information
The device has been evaluated to meet general RF exposure requrement. The
device can be used in portable exposure condition without restrictions.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>