Sonos Outdoor Speakers- Pair Of Architectural Speakers-Complete Features/User Guide

Sonos Outdoor Speakers- Pair Of Architectural Speakers

Specifications

• Product Dimensions
  12.2 x 8.86 x 7.48 inches

• Item Weight
  8.79 pounds

• Speaker Type
  Outdoor

• Recommended Uses For Product
  Outdoor

• Special Feature
  Subwoofer, Radio

• Brand
  Sonos

Introduction

Sonance’s architectural speakers are designed for outdoor use. With Sonos Outdoor by Sonance, you can enjoy precise sound in your backyard or on your patio. To get the complete Sonos experience, use Amp to power these wired speakers. These speakers are resistant to moisture, water, salt spray, heat, UV radiation, and freezing conditions. On a single Sonos Amp, the Sonos Amp can power up to three pairs of Sonos Architectural speakers. Sonos and Sonance have collaborated on a range of passive architectural speakers optimized for Sonos Amp, with a common dedication to exceptional sound and great design.

What’s In the Box?

• 2 each Outdoor Speakers
• Speaker Grilles
• FastMount Brackets
• Wiring Terminal Covers
• Installation Manual

Speaker Placement

SONOS OUTDOOR by SONANCE speakers are highly weather-resistant, and when mounted outdoors will perform exceptionally well for years, even under adverse weather conditions. The FastMount bracket system makes it easy to mount the speakers in a variety of positions and locations: (see figure 1).

The best performance is obtained by placing the speakers directed toward the listening area.

• If you are mounting the speakers above or below ear level, pivot them up or down to direct the sound towards the listeners.
•  You can orient the speakers either horizontally or vertically without affecting the sound quality. For vertical orientation, please ensure that the tweeter is in the upright position with the SONOS logo toward the bottom as shown in the “pole mount” illustration in figure 1.

Types of Wire

When installing SONOS OUTDOOR by SONANCE Speakers careful consideration should be made when determining the speaker placement and wire gauge. Refer to the wiring chart (see figure 2) to determine which size wire to use over the given distance between the SONOS Amplifier and the speakers.

Connecting and Assembling

WARNING
TURN THE AMPLIFIER’S POWER OFF UNTIL YOU HAVE COMPLETED ALL OF THE CONNECTIONS AND HAVE DETERMINED THAT THEY ARE CORRECT. (IF THE AMP’S AC PLUG IS ACCESSIBLE WE RECOMMEND THAT YOU UNPLUG IT FROM THE WALL OUTLET TO AVOID ACCIDENTAL TURN- ON AND POSSIBLE DAMAGE TO THE AMPLIFIER.)

1. In most cases, you will be able to attach the FastMount brackets directly to the mounting surface. Run the speaker wires from the amplifier to the speaker locations and through the holes in the brackets if used (see figure 3).

NOTE TO INCREASE WATER RESISTANCE AND MAKE INSTALLATION EASIER, THE SPEAKER WIRE TERMINALS ARE LOCATED ON THE SPEAKERS’ FRONT PANEL. BE SURE TO LEAVE ENOUGH WIRE AT THE SPEAKER LOCATION TO FEED THROUGH THE TUNNEL IN THE SPEAKER ENCLOSURE AND CONNECT TO THE TERMINALS ON THE FRONT.

2. Attach the FastMount brackets to the mounting surface using hardware (not included) that is appropriate for the type of surface (see figure 3).
   If the installation requires that the speaker be mounted in a corner, attach the bracket with hardware (not included) through the slots in the angled corners (see figure 4).

3. If the installation requires that the speaker be mounted on a pole you can attach the FastMount brackets to the pole using 2.5” U-bolts (not included) (see figure 5).

4. Feed the speaker wires from the bracket into the wire entry grommet on the back of the speaker, through the wire tunnel and out the opening on the speaker’s front panel (see figure 6).
   
   The grommet forms a water-resistant seal around the speaker wire.
   Make sure there is enough slack in the wire to allow the speaker to pivot on the bracket.

5. Slide the speaker onto the bracket and firmly snap it into place at the top and bottom of the speaker. Pull enough wire through the front of the speaker to allow connection to the terminals (see figure 7).
   NOTE
    BE SURE THAT THE BRACKET CLIPS SNAP COMPLETELY INTO PLACE TO PREVENT ANY BLOCKAGE WITHIN THE SPEAKER PERIMETER WHERE THE GRILLE IS TO BE INSERTED. PULL THE SPEAKER GENTLY TOWARD YOURSELF TO VERIFY THAT IT IS SECURELY IN PLACE.
   

6. Connect the speaker wires to the speaker’s terminals:
   Strip about .5” of insulation from each conductor and twist the strands together or tin them with solder.
   Press down on the tops of the connectors to open them.
   Insert the wires into the connector holes(see figure 8).
   Release the connectors.
   
   The binding post connectors can accept wire up to 14 gauge.
   Double-check that you connected all of the wires properly (amplifier ‘+’ to speaker ‘+’; amplifier ‘–’ to speaker ‘–’) at all connections.
   IMPORTANT
   BE SURE NOT TO LET ANY STRAY ‘+’ AND ‘–’ WIRES TOUCH EACH OTHER. TOUCHING WIRES CAN CAUSE A SHORT-CIRCUIT THAT COULD DAMAGE YOUR AMPLIFIER

7. Fit the wiring connector cover into the recess in the speaker’s front panel. The cover should fit tightly but can be removed if the speaker needs to be disconnected (see figure 9).

8.  Fit the grille onto the speaker by aligning the edges of the grille with the groove of the speaker face perimeter and pressing firmly until it is snugly in place (see figure 10). Start by inserting and pressing along the long edge, then insert one of the short edges. Continue with the other long edge, and finally the other short edge.
   NOTE ALL SONOS OUTDOOR BY SONANCE SPEAKERS ARE COMPATIBLE WITH OMNIMOUNT STAINLESS STEEL 15.0 C AND 15.0 W SERIES SPEAKER BRACKETS. FOR MORE INFORMATION CONTACT YOUR SONOS AUTHORIZED DEALER OR GO TO WWW.OMNIMOUNT.COM

Removing the Speaker

To remove the speaker from the FastMount bracket, gently pull the grille from each corner until it is freed from the grooves of the speaker’s face. Once the grille is removed, remove the wire connector cover and disconnect the speaker wire from the spring-loaded terminals. Next, use your thumbs to press outward on the top and bottom tabs of the speaker’s face, releasing the clips of the bracket. While pressing the tabs, pull gently on the speaker away from the bracket.

Pivoting the Speaker

You can rotate the speaker in the bracket to direct the sound
towards the listening area.

1.  Unlock the slide locks on the speaker pivots by moving them towards the rear of the speaker as indicated by the unlock symbol (see figure 11).
2.  Rotate the speakers to the desired position.
3.  Lock the slide locks by moving them towards the front of the speaker as indicated by the lock symbol (see figure 11).

Unlocking SONOS Audio Enhancements

SONOS OUTDOOR by SONANCE speakers includes exclusive audio enhancements when used with a SONOS Amp. Use the free SONOS app to unlock them.
Audio enhancements include:

•  Custom EQ settings
•  Gain adjustment
•  Dynamic bass extension
•  Signal limiting/loudspeaker protection

To UTILIZE THE AUDIO ENHANCEMENTS

1.  Download the SONOS mobile app from the app store on a mobile device.
2.  Open the app and follow the prompts to set up your SONOS system.
3.  After Amp is set up, go to Room Settings and choose the room your speakers are in.
4. Select Advanced Audio -> Detect SONOS Architectural to unlock the audio enhancements.

Painting the Speaker and Grille

All SONOS OUTDOOR by SONANCE speakers features a tough polypropylene enclosure that can be painted. SONOS recommends using weather-resistant outdoor paint and a spray gun to paint the speakers.

1.  If it has already been installed, remove the grille from the speaker.
2.  To protect the speaker driver units during painting, place the grille on a piece of cardboard and trace around its outline. Then cut the cardboard just inside of the trace line and fit this “paint shield” into the speaker’s baffle. (be careful not to damage the driver components while fitting the paint shield).
3.  Paint the speaker the desired color according to the paint manufacturer’s instructions. Remove the paint shield after the paint has thoroughly dried.
4. Paint the grille separately from the speaker using very thin paint (5:1 thinner: paint ratio). Avoid plugging the grille holes with excess paint.
5.  After the paint has thoroughly dried, re-attach the grille to the speaker and remount

TWO (2) YEAR WARRANTY

We stand for the quality of our SONOS products. We offer a 2-year full warranty on all products sold. The details of this warranty are set out in our End User License and Warranty Agreement (EULA). A summary of the conditions of the SONOS Warranty is set out below. In the event that there is any conflict between this summary and the EULA, the EULA will control. Your local consumer protection laws may provide additional rules on warranty. The SONOS Warranty does not in any way restrict the rights that you may have under such rules. The SONOS Warranty covers defects in materials and workmanship in every SONOS product for two (2) years from the date of shipment from SONOS or the date of the original retail purchase from an Authorised SONOS Dealer. The SONOS warranty does not guarantee that SONOS products will at all times operate without interruption or will be error-free, or that all errors may be corrected. If you have a valid claim under the SONOS Warranty and have returned the product in accordance with the procedure set out below, we will repair or replace the defective product free of cost. If we determine that the problem is not covered under the SONOS Warranty, we will notify you and inform you of service or replacement alternatives that are available to you for an additional fee. The warranty period is not extended if we repair or replace your product.

Your SONOS Warranty is transferable with ownership, so if you give or sell the SONOS product to someone during the guarantee period, it’s still covered. There are some exclusions to the SONOS Warranty, including but not limited to problems that result from external causes such as accident, abuse, or misuse;

Use that is not in accordance with SONOS’ product instructions; products with missing or altered serial numbers; products that have had their housings opened or are otherwise tampered with; or problems caused by using third party accessories, parts, or components.
© 2018 SONOS Inc. All rights reserved.

SONOS, Play:1, and all other SONOS product names and slogans are trademarks or registered trademarks of SONOS, Inc. SONOS Reg. U.S. Pat & TM Off. Use of the Works with Apple badge means that an accessory has been designed to work specifically with the technology identified in the badge and has been certified by the developer to meet Apple performance standards. Apple is a trademark of Apple Inc., registered in the U.S. and other countries.

We stand for the quality of our Sonos products. We offer a one (1) year full warranty on all products sold. The details of this warranty are set out in our Terms of Use, License, and Warranty Agreement – https://www.sonos.com/en- us/legal/terms-of-use

A summary of the conditions of the Sonos Warranty is set out below. In the event that there is any conflict between this summary and the Terms of Use, License, and Warranty Agreement, the Terms of Use, License, and Warranty Agreement will control.

Your local consumer protection laws may provide additional rules on warranty. The Sonos Warranty does not in any way restrict the rights that you may have under such rules.

The Sonos Warranty covers defects in materials and workmanship in every Sonos product for one (1) year from the date of shipment from Sonos or the date of the original retail purchase from an Authorised Sonos Dealer. The Sonos warranty does not guarantee that Sonos products will at all times operate without interruption or will be error-free, or that all errors may be corrected.

If you have a valid claim under the Sonos Warranty and have returned the product in accordance with the procedure set out below, we will repair or replace the defective product free of cost.

If we determine that the problem is not covered under the Sonos Warranty, we will notify you and inform you of service or replacement alternatives that are available to you for an additional fee.

The warranty period is not extended if we repair or replace your product.

Your Sonos Warranty is transferable with ownership, so if you give or sell the Sonos product to someone during the guarantee period, it’s still covered.

There are some exclusions to the Sonos Warranty, including but not limited to:

•  Problems that result from external causes such as accidents, abuse, or misuse;
•  Use that is not in accordance with Sonos’ product instructions;
•  Products with missing or altered serial numbers;
•  Products which have had their housings opened or are otherwise tampered with; or
•  Problems caused by using third-party accessories, parts, or components.

Frequently Asked Questions

• Are this authentic Sonos? The same speakers are $300 more direct from Sonos
  Yes. They are authentic, new, current-generation outdoor Sonos speakers.

• Is the amp required to use one set of speakers? Or only if you want to connect multiple sets of speakers?
  The amp is needed for one set of speakers.

• How many of these speakers can I pair up together? For example, can I put 4 of them in my backyard and run them together?
  They need an amp source or speaker selector hooked up to the receiver they sound great one of the best weatherproof speakers I’ve had.

• Are these paintable?
  Yes, the manual states to recommend using weather-resistant outdoor paint using a spray gun. Manual goes into more detail

• Do you need to use Sonos speakers with the new Sonos amp? what do the Sonos speakers add?
  The outdoor speakers have been on back-order for months now so I can’t say what the advantage is to that pairing but I have actually been using the Klipsch aw-650s with this amp and it works and sounds great.

• How to mount these to siding without knowing where a stud is?
  Use a stud finder I mount mine under gutters to give them a little more protection also bought weatherproof covers for the winter

• Are these compatible with a Marantz or Denon amplifier? Continuous watts, and max watts?
  Max watts is 150 however mines blew way below that wattage.

• Will these speakers work without an amp?
  So these are exactly like any other outdoor speaker– All speakers are able to be connected if you have a Sonos amp!

• Are these speakers waterproof? will they last open doors near a swimming pool?
  Yes, they are waterproof. However, I went through 3 pairs of them because they only lasted a couple of weeks each. Try something else would be my suggestion.

• Can you mount these to siding without wood? Not sure how I can find wood underneath.
  You need a good mounting surface there very expensive you don’t want someone to steal them or the speaker falling off due to music vibration.

https://m.media-amazon.com/images/I/A1nU489puxL.pdf

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>