Leedarson 2AB2Q LED Lamp User Guide
- June 5, 2024
- LEEDARSON
Table of Contents
Leedarson 2AB2Q LED Lamp User Guide
Product Specification
| Product Name | LED LAMP |
|---|---|
| Model No. | 11A21100WCCTMxx |
| FCC ID | 2AB2Q-11A21100WCCTM |
| Microwave Frequency Band | 5.8 GHz±75MHz |
| Working Voltage | 120Vac |
For additional help, regulatory and safety Information, please go to: Federal
Communications Commission (FCC) Interference Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
The grantee is not responsible for any changes or modifications not expressly
approved by the party responsible for compliance. Such modifications could
void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving
- Increase the separation between the equipment and
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
- Motion Sensor Detect Range: 25
- Hold-time: Light will keep stay on 35s ±3 after motion stops
- When the bulb powered on, the bulb will lights on about 10s , then light off, the motion sensor starts to detect the react it based on the movement