Leedarson Lighting 10ASBA800WG Smart LED Bulb User Guide
- June 6, 2024
- Leedarson Lighting
Table of Contents
Leedarson Lighting 10ASBA800WG Smart LED Bulb
Quick Start Guide
The following are the general user guide:
Step 1:
Screw the bulb into a standard socket.
Step 2:
Turn on the bulb with your wall switch to apply power to the bulb.
If you’re not using a wall switch, then use your alternate method to apply
power to the bulb.
Step 3:
Get the LEEDARSON App for Android or iOS.
Step 4:
Create an account and sign in, enable your location and open your Bluetooth.
Step 5:
Press ‘+’ button to add the light bulb. Step 6:
Automatic discovery devices which to be added in the top left corner，then
follow the instructions on App.
Operation
Resetting Bulb：
Restore the bulb(s) to factory default by switching 6 times. 
Safety Instructions
Please read, keep and follow these instructions before installation:
- Switch off the power supply to the socket and allow sufficient time for the bulb to cool before removing the bulb from the fitting
- Warning: Risk of Electric Shock. Do not attempt to disassemble bulb.
- Not suitable for use with standard wall dimmers
- Suitable for use in operation environment between -4℉ and 104℉（-20℃and 40℃）
- Not for use in emergency lighting.
- The bulb is not suitable for totally enclosed fixtures.
- Do not clean the bulb when it is on and connected to the power supply
- Do not place the bulb on hot surfaces
- Dispose of this device in accordance with disposal laws in your area.
- For additional help, regulatory and safety Information, please go to:
www.leedarson.com
FCC Statment
For additional help, regulatory and safety Information, please go to:
Federal Communications Commission (FCC) Interference Statement
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
The grantee is not responsible for any changes or modifications not expressly approved by the party responsible for compliance. Such modifications could void the user’s authority to operate the equipment.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on,the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance of 20cm between the radiator and your body.
CAUTION:
DO NOT USE WITH STANDARD DIMMERS, SEE
INSTRUCTIONS
- NOT FOR USE IN TOTALLY ENCLOSED LUMINAIRES
- SUITABLE FOR DAMP LOCATIONS
- THIS DEVICE IS NOT INTENDED FOR USE WITH EMERGENCY
EXITS
Only use the control provided with or specified by these instructions to
control this lamp. This lamp will not operate properly when connected to a
standard (incandescent) dimmer or dimming control.