Leedarson Lighting 11A19060WRGBW01 LED Lamp User Guide
- June 5, 2024
- Leedarson Lighting
Table of Contents
11A19060WRGBW01 LED Lamp
User Guide
Product Specification
| Product Name | LED LAMP |
|---|---|
| Model No. | 11A19060WRGBWO1 |
| FCC ID | 2AB2Q-11A19060WRGBK |
| Operating frequency | 2402-2480MHz |
| Working Voltage | 120Vac |
| Support Function | BLE(1Mbps/2Mbps/125kbps/500kbps) |
| Number of channels used | 40 |
| Operating Temperature | -20-40°C |
| Manufacturer & Address | LEEDARSON LIGHTING CO., LTD. |
Xingda Road, Xingtai Industrial Zone, Changtai County, Zhangzhou, Fujian, China
The following is the general user guide:
Step 1:
Screw the bulb into a standard socket.
Step 2:
Turn on the bulb with your wall switch to apply power to the bulb. If you’re
not using a wall switch, then use your alternate method to apply power to the
bulb.
Step 3:
Remove the transparent plastic sheet on the remote control and supply power to
the remote control.
Step 4:
Press the first two keys of the remote control at the same time to pair the
remote control and the bulb.
Step 5:
After pairing, you can use the remote control to adjust the bulb.
For additional help, and regulatory and safety information, please go to
Federal Communications Commission (FCC) Interference Statement This device
complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference
that may cause undesired operation.
The grantee is not responsible for any changes or modifications not expressly
approved by the party responsible for compliance. Such modifications could
void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
a minimum distance of 20 cm between the radiator and your body.
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
Radiation Exposure Statement:
This equipment complies with IC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
a minimum distance of 20 cm between the radiator & your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>