genexis P3414B Fiber Twist Series Installation Guide
- June 5, 2024
- genexis
Table of Contents
genexis P3414B Fiber Twist Series
Button overview
Port overview
LED overview
Installation guide
Various translations of this document (if available) and additional product
information can be found on
https://genexis.eu/product/fiebertwist/downloads
-
Box contents
- Genexis FiberTwist (active device)
- Power adapter
- Labels (self-adhesive)
-
Label position
The product label is positioned on the back of the active device. -
Preparation
Ensure there is a power socket within reach of where the device is being installed. -
Important:
Instructions need to be followed precisely and uninterrupted. This minimizes the risk of damage (a severe degradation of signal quality) to the fiber optic connectors.
Remove Blind Cover (if present)
- Press and hold the unlock button (see button overview).
- Rotate the Blind Cover counterclockwise till it blocks.
- Remove the Blind Cover from the baseplate (FTU) by pulling it towards yourself.
- Store the Blind Cover in a safe place.
Remove dust cap
- Take the FiberTwist out of the box.
- The dust cap is connected to the red string located on the rear of the FiberTwist.
- Remove the dust cap by pulling the red string.
- Store the dust cap in a safe place.
Twist!
- Place the FiberTwist on the FTU as shown in the picture below.
- Rotate clockwise until it clicks into place.
- Make sure the FiberTwist is aligned squarely on the FTU, each edge must line up directly with the FTU below.
Your FiberTwist is now installed!
Connecting the FiberTwist
- If required, connect your telephone to the phone port via an RJ11 network cable.
- If required, connect your personal devices to the LAN ports via an RJ45, network cable.
- Connect the supplied power adapter to the Fiber Twist and plug the adapter into a power socket.
If at some point in the future it becomes necessary to uninstall the Fiber Twist, please place the Blind Cover back on the FTU immediately and put the dust cap back on the Fiber Twist.
Laser safe!y
This product contains a laser that emits invisible light. It is a Class #
Laser product, which means it is safe under all conditions of normal use.
However, it is still advised to not look directly into the (fiber connector
when the product is
powered on.
EU Declaration of Conformi$y
Hereby, Genexis Netherlands B.V. declares that the product FiberTwist p341b4
is in compliance with Directives 2014/30/EU,2014/35/EU, 2011/65/EU, Delegated
Directive 2015/863 and Ecodesign Directive 2009/125/EU.
The full text of the EU declaration of conformity is available at the
following internet address: http://genexis.eu/product/fibertwist/red
/fibertwist-p3414b
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>